Hello, I've been designing and building a number of TIG welded aluminum hulls for my water quality and bathymetry projects and have one that I need to sell. This design is very efficient - but it turned out not to be the right design for this particu
Read more…Let me start off by apologizing if this is considered spam, but I wanted to let you guys know that I have decided to start a small side gig and build/sell some hulls for Adruboat projects. I’m looking for any input, suggestions, comments, and to spre
Read more…So, the post I made about some features in ArduRover has sparked a discussion about perhaps creating a dedicated ArduBoat firmware. That post is located here: http://diydrones.com/group/arduboat-user-group/forum/topics/arduboat-any-way-to-have-it-hol
Read more…Hello! I am rebuilding an old APMBoat from a few years ago, and at the time was unable to find a way to get the boat to hold position. When it reached the final waypoint, it would just stop and float with the current/wind. The only thing I was able t
Read more…Hello! I'm having an issue and am at my wits end, please help!
I have a Pixhawk with Turnigy 9XR and OrangeRX R800X Radio which has "SBUS" output. I connected the SBUS out to the RC IN on the pixhawk and it worked great for maybe 10 flights. Then, wh
Hello,
I've started a part time company building and selling small drones, such as FX61 Phantoms, multirotors, and custom stuff as needed. (Based on APM/pixhawk, etc)
My question is: I have a customer interested in 10 drones (50 originally, but I can
Hello! I am having a problem where my aircraft will reduce throttle to zero when I switch on Auto or Loiter Mode.
Here are a few things to note:
Hello,
I have what is probably a dumb question but am hoping soemone can help or point me in the right direction... but I just built a boat using APM 2.5, 915mhz 3DR radio. It's working great, I can get it to following waypoints etc - but I am having
Read more…Hello,
I have an APM 2.5 installed in a flying wing airframe. I previously had this APM in a multicopter and had it working well. I installed the ArduPlane V2.72 on the APM, and downloaded and installed the Skywalker Parameters, and calibrated my rad
Hello!
Has anyone had any success in getting your quad to have any obstacle avoidance abilities? I'm not talking about any complex pathing, but rather (at least in my case) will allow for low altitude forward flight, and if a weed or bush is detected
Hello all,
I've got my quad working pretty well - has about 3 hours of flight time thus far. I want to set up a flight path which basically repeats either many times, or indefinitely. I figured the DO_Jump would be my method of doing this - but I went
Read more…I just got my quad ready for initial flight testing today - everything works good at first, it's pretty solid, even with less than perfect weather conditions. However, after a few minutes of flying, it will flip over and crash upside down. (I didn't
Read more…