Gender
Male
About
Location
Eindhoven
Please tell us a bit about your UAV interest
Aereal photography, Athonomous flight
Hometown:
Eindhoven Netherlands
Activity Feed
"@ Richard: I havehad it working with 2s and 3s batteries without any problem. Somewhere in my previous posts I mentioned where you can find tuning information. Worked fine for me, and I am not an expert at all."
"I think I heard that same noise when I was tuning PID at some point. It did go away when I reached the (for me) optimal settings."
"@mP1: yes, this refers to the GUI that is included in the zipfiles that you can download here: http://code.google.com/p/brushless-gimbal/downloads/list
This is a maual i found as well:…"
This is a maual i found as well:…"
"I have had it working with directly connecting a 2S lipo. Currently mine runs on a 3S and I read you can go up tp 6S but I am not going to try that. No bec required."
"Just for the record... In the Pitch and Roll tab the RC portion of the screen is used to set the manual Pitch and Roll functionality (if you connect a lead to A1 and ground you can use a second free channel to use for manual roll)
The RC-Channel is…"
The RC-Channel is…"
"Turns out that I was mistaking a lead to be ground.. It wasn't. Now I have the manual pitch on channel 8 of my Turnigy 9X working as well!"
"Randy, there is only one lead going to the receiver, not to your Naza! It is intended to enable manual tilt but I have not got it working yet..."
"Hi Richard, It is my understanding that PID's differ gratly between versions. Below are my settings for Roll and Pitch. Please note hat both motos are reversed. Hope this is of help to you."
"Hi Oliver. The controller is based on an Arduino, much like the APM is. I found this usefull info on RC groups: http://www.rcgroups.com/forums/showthread.php?t=1901828. I think it tells you all you need to know.
Best,
Eric"
Best,
Eric"
"Sure looks good! I have the same gimbal and it is certainly not bad at all. The controller is the Martinez open source controller and gui and software can be found here: http://code.google.com/p/brushless-gimbal/downloads/list.
I was not yet able…"
I was not yet able…"
"Same problem here, i have it only with my 2.0 board and Turnigy Plush 30 escs. For now i am using a separate battery to power up the apm before aplying lipo to the escs but hopefully a fix will be created for this.
Thanks!
Eric"
Thanks!
Eric"
"So the problem is that the APM get's stuck in ESC calibration mode, which obviously freezes the access to the board through Mavlink. It appears to be limited to be limited to ArduCopter 2.9.1.b. If I install other software, it seems to be working…"
"Any thoughts anyone?"
Hi all,On the forum I only came accross one topic that resembles my problem but I am pretty sure that the resolution in that tread will not help me at all. I have upgraded to 2.9.1.b (hexa) through USB. this process completed without any…
