www.pixhawk2.comPixhawk 2 is a small cube, with a 38.5mm square footprint.All connection to the cube is via a DF17 connector coming out the bottom of the cube.This modularity allows for multiple form factors to suit multiple platforms.For the stand alone market, it will be coming out in two form factors to start with, a "Full" configuration, and a "mini" configuration. The full will have connectors for everything, the kitchen sink.... While the mini is restricted to the bare essentials.For RTF's or kit aircraft, I am working on a series of plug and fly systems, that allow you to remove most of your wiring from your aircraft, and take advantage of the easy to use modular structure.The cube also has a massive quality advantage. Given that every single pin is available on the DF17 connection on the base, it allows complete factory full motion testing and calibration of each cube.Pixhawk 2 is continuing to grow. When we release the Pixhawk 2 stand alone, it will be using the latest sensors available on the market, in a form factor that allows the ultimate in flexibility.Please note. Pixhawk 2 Stand alone is NOT a 3DR product. It is a community driven product, designed by the community for the community.A key requirement for my partner companies who will be making this will be active support of the community.Looking forward to announcing more info soon!Philip RowseLead Systems EngineerProfiCNCLead EE on Pixhawk 2 PX4 and Ardupilot Dev team member(formally 3DR sponsored)
What are the flight limitations of the pixhawk 2 with default computer on-board? Like attiude, rates, accelerations, resolution , speeds and pressure range?
We ordered a power module in early January and can't contact them. There are no contact numbers or email address on the website. We tried the contact form, but no response.
Replies
Hey People,
What are the flight limitations of the pixhawk 2 with default computer on-board? Like attiude, rates, accelerations, resolution , speeds and pressure range?
What is the Edison cheap is for? is it a must?
Hi All, has anyone ordered anything through the Pixhawk Store;
http://pixhawkstore.com.au/about-us/
We ordered a power module in early January and can't contact them. There are no contact numbers or email address on the website. We tried the contact form, but no response.
Does anyone have contact details or knows them?
https://www.facebook.com/groups/pixhawk2/
Garvit said:
Hello, from where can I get the startup manual of Pixhawk 2 for user startup?
Or the Pixhawk 2 Facebook page.
Will the AUX out be 3.3v or 5v? Curious because 5v is easier to set up CHDK camera triger.
Noticed on http://www.proficnc.com/ it shows Pixhawk 2.1
http://www.proficnc.com/
Does anyone have any news on the release of Pixhawk t2 to the public?.
-
1
-
2
-
3
-
4
-
5
of 15 Next