Gender
Male
About
Location
Redmond, WA
Please tell us a bit about your UAV interest
Designing automated monitoring solutions
Hometown:
Redmond
Activity Feed
"This was just one more issue I had with the Pixhawk (no sonar support, no flow sensor support, glitchy initiation, rough loiter) so I was forced to switch back to DJI + Arduino :(
I'll keep my eye on how the Pixhawk evolves and hope to retry it…"
I'll keep my eye on how the Pixhawk evolves and hope to retry it…"
"Bump: Can someone who's using the PX4Flow with a Pixhawk please tell us how they did it?"
"The PX4Flow site have instructions for how to hook it up to a Pixhawk.
But the instructions are written for people who have a deeper level of Pixhawk knowledge than the myself.
Can someone explain how I can get to the file that needs to be edited??…"
But the instructions are written for people who have a deeper level of Pixhawk knowledge than the myself.
Can someone explain how I can get to the file that needs to be edited??…"
"Thanks Gary,
I read this section before I bought it and assumed that I would be able to work out what it meant once I had the sensor and the Pixhawk:
"
Pixhawk Setup
Upload firmware to PX4Flow
Connect PX4Flow UART3 to any available serial on the…"
I read this section before I bought it and assumed that I would be able to work out what it meant once I had the sensor and the Pixhawk:
"
Pixhawk Setup
Upload firmware to PX4Flow
Connect PX4Flow UART3 to any available serial on the…"
Hi,Has anyone been able to successfully install and use the OFS&Sonar combo that 3DR sells?I've managed to update the firmware and focus the link using the ground control software but the next step seem to be to change some boot up script and I have…
"Thanks Glenn!
So, hooking up an Arduino to the APM (Pixhawk in my case) is best done over the telemetry port?
I guess that would work.
Let me read that back to you to see if I understood you correctly:
To tell the Pixhawk where to go I would create…"
So, hooking up an Arduino to the APM (Pixhawk in my case) is best done over the telemetry port?
I guess that would work.
Let me read that back to you to see if I understood you correctly:
To tell the Pixhawk where to go I would create…"
"Ping!?Is no one is using their Pixhawks together with an Arduino?"
"Check out the different versions of FLIR Tau2.
They are lightweight (130gr I think) and built for such use.
The 120 pixel version is the entry model."
They are lightweight (130gr I think) and built for such use.
The 120 pixel version is the entry model."
Hi,What's the preferred method of interfacing the Arduino with a Pixhawk? And is there a guide out there somewhere for it?I'd like to use an Ardunio(+Pixy) to locate and move a quad copter between indoor waypoints.The only method I'm aware of is to…
"I've got the same problem.
I'm planning to use two of the servo outputs to feed into my EagleTreeSystems OSD so I really need to relocate flight mode.
Is there a way to switch the flight mode channel to 6 in the software or is it hardcoded to…"
I'm planning to use two of the servo outputs to feed into my EagleTreeSystems OSD so I really need to relocate flight mode.
Is there a way to switch the flight mode channel to 6 in the software or is it hardcoded to…"
