About

Gender

Male


Location

Apo, AE


Please tell us a bit about your UAV interest

N/A


Activity Feed

Biz18434 posted a discussion in ArduRover User Group
Hello,  I have Traxxas Slash 4x4 R/C system and an APM2 coupled to a FrSky DJT receiver and a 9XR transmitter also a Sharp sonar. My APM2 modes are Auto, Steering, Learning, Learning, Manual, Manual. All my modes except steering work fine. When I…
Apr 14, 2013
Biz18434 replied to Tom Gibson's discussion APM2 magnetometer in ArduRover 2.20 in ArduRover User Group
"Comment by Jean-Louis Naudin on June 13, 2012 at 12:16pm Hello,I have just updated the APMrover 2.20 to 2.20a with a small tuning about obstacles avoidance with the Shap sensor. If the TRACE is ENABLED you will see in the planner message that the…"
Sep 3, 2012
Biz18434 replied to Tom Gibson's discussion Standard Parameters in ArduRover User Group
"Hello, I cannot answer the first question and I had asked about Max Throttle in the Discussion forum.  This is the answer I received;
 
Comment by u4eake on August 10, 2012 at 3:57am There are 2 parameters that influence this, cause I found that the…"
Aug 27, 2012
Biz18434 commented on Jean-Louis Naudin's blog post APMRover 2, a fun UGV project for full autonomous recon missions...
"Thank you u4eake, it worked great.  Would that same logic work on Throttle_min? If I set throttle_min to 50 would that mean no throttle?  I believe it was set to zero at default.  Again thank you very much for your help.
Biz"
Aug 11, 2012
Biz18434 commented on Jean-Louis Naudin's blog post APMRover 2, a fun UGV project for full autonomous recon missions...
"Hello,I have a Traxxas Slash 4X4 with an ArduPilot Mega 2.0 and a Sharp IR distance sensor for obstacle avoidance. I have no issues running my rover from my RC controler but when I switch to Auto my rover takes off at full speed. After watching…"
Aug 9, 2012
Biz18434 commented on Jean-Louis Naudin's blog post APMRover 2, a fun UGV project for full autonomous recon missions...
"Hello eake,You said "I have removed the compass heading calc out of the if statement, so that it gets executed with every update_gps call and now my gps is responding crisp in mission planner, wether the gps had fix or not. The heading in mission…"
Aug 5, 2012
Biz18434 commented on Jean-Louis Naudin's blog post APMRover 2, a fun UGV project for full autonomous recon missions...
"Hello,
  When the Rover is in AUTO mode what parameter is used to control the throttle?
Thank You,
Biz"
Jul 20, 2012