Gender
Male
About
Location
North Little Rock, AR
Please tell us a bit about your UAV interest
Aerial videos
Hometown:
North Little Rock, Arkansas
Activity Feed
"When reading the graphs is it best/better to have the graph lines at or closer to center or zero?"
"Well I had been flying very close to my house and my neighbors house also and we both have steel siding. So I will take it across the street to an opne area and see if there is any difference in the flight. And many thanks for checking my files."
"Maybe these I hope
2015-12-06 13-46-54.tlog2015-12-06 14-18-31.bin2015-12-06 13-55-37.tlog"
2015-12-06 13-46-54.tlog2015-12-06 14-18-31.bin2015-12-06 13-55-37.tlog"
My Pixhawk flies level in stable mode and it holds altitude some but could hold it better. But in loiter modes its bad and does not hold. Myself i can't make heads or tails from the graphs except for a bunch of lines so I"m open for any suggestions…
"I am using a piece of memory foam I got from an upholstery shop. And I thought that I was getting too much vibration from it off the frame. But I guess its better than the foam from 3DR then. Yea I did not get to do an auto tune the first time…"
"I meant the compass calibration. And yes I have tried loiter mode and it did hold pretty nice. I think that some of my problems are from vibrations and I have a pixhawk anti-vibration mounting base on order now. I"m going to remove the pixhawk and…"
"I hope this works
https://drive.google.com/file/d/0B3Nv4kLq69xJNTgxNXY0WnA5d0k/view?u..."
https://drive.google.com/file/d/0B3Nv4kLq69xJNTgxNXY0WnA5d0k/view?u..."
"Yes I have done that and I get a bunch of files that say 1.BIN thru 65.BIN that I can't open of upload to this site."
"Not sure how to get a flight log but I will try and see what I can do. I have just completely reinstalled everything from MP to the latest FW and I hope to get a good test flight today."
"I use sbus from my X8R rx and on my Taranis the throttle is channel 3"
After calibrating the gps and accel several times I still have a left roll on my quad, I run a Taranis tx with a X8R rx on 4S battery. I was told that my compassmot was not set correctly but after several resets it still moves left with the right…
I have been trying to change the "P" in the altitude section but for some reason it will not change. Right now its 1.000 and I was going to change it to 1.2 or 1.3 but when I change the setting and click write parameters it returns back to the…
Can someone review my eeprom and compare it with their's or another hexa copter and see if its a flyable type program.? I'm kind of new to the Taranis and I would like to know if its a good eeprom. I have built a Tarot 680MM Pro and I'm using a…
"Logical switches replaced the Custom switches"
