About

Gender

Male


Location

Baden-Wuerttemberg


Please tell us a bit about your UAV interest

Trying to get to know new things, always.


Hometown:

Karlsruhe


Activity Feed

Boris Matuschka commented on Jean-Louis Naudin's blog post APMRover 2, a fun UGV project for full autonomous recon missions...
"so I see the xbee must be connectet to uart 3? do I have to set the solder points on the down side of the apm2 ?"
Jul 14, 2012
Boris Matuschka commented on Jean-Louis Naudin's blog post APMRover 2, a fun UGV project for full autonomous recon missions...
"Could somebody help me getting my xbees to work? I have downloaded the latest Firmware 2.2 and uploaded to my apm2. in the code I have set it to APM2 and LITE DISABLED. But I do not get a xbee connection. What do I have to set, that the xbees will…"
Jul 12, 2012
Boris Matuschka replied to Boris Matuschka's discussion Ardupilot Antenna Tracking via Videolink?
"Hey Samuel, is there any news regarding your project?
cheers Boris"
Jul 7, 2012
Boris Matuschka replied to Dwgsparky's discussion Xbee problem
"Thank you Barry! You saved my day after struggeling arround with my xbee modules! thanks fpr your pictures!!!!!
Regards,
Boris"
Jun 22, 2012
Boris Matuschka commented on Jean-Louis Naudin's blog post APMRover 2, a fun UGV project for full autonomous recon missions...
"This is in my interest, too!"
Jun 14, 2012
Boris Matuschka replied to Boris Matuschka's discussion PPM input logic level?
"ok. I watched the links nick gave me; can you tell me which of the connectors would i have to connect? I get from the reciver the gnd, + volatage and signal line; where shoud i connect it eg to the levl shifter from diydrones? sorry for askin, but i…"
Jun 1, 2012
Boris Matuschka replied to Boris Matuschka's discussion PPM input logic level?
"ok thanks a lot for your answers this helps me a lot. ill try it with the given scematic. 
thanks again to you jake ad nick :-)
Boris"
Jun 1, 2012
Boris Matuschka posted a discussion
Hi folks,I recently tried to connect a ezUHF receiver to the ppm input of the APM2. I soldered the jumper on the back and connected the cable to ch5. This setup was working fine with a Simprop 2G4 receiver in ppm mode. When I now connect the ezUHF…
Jun 1, 2012
Boris Matuschka replied to David Baker's discussion MinimOSD says "Update Charset" on bootup, must reset first
"Hey David, thanks for that :-)"
May 24, 2012
Boris Matuschka posted a discussion
Hi everybody,I am wondering if there isnt a possibility to get an antennatracker running for the ardupilot without having xbees installed. Is there already a solution to include the data stream for the tracking information for the ardustation into a…
May 12, 2012
Boris Matuschka commented on Hai Tran's blog post Ardustation 2: Antenna Tracking, Mavlink, Flight Data for Arducopter 2
"Thank you very much Heino! For you reply to my mail, also :-) very appreciated!"
May 1, 2012
Boris Matuschka commented on Hai Tran's blog post Ardustation 2: Antenna Tracking, Mavlink, Flight Data for Arducopter 2
"Can I use the antenna tracker feature with arduplane, too?"
Apr 29, 2012