Gender
Male
About
Location
Buenos Aires, Argentina
Please tell us a bit about your UAV interest
I have several planes (Event 38) and hexacopter, DJI F550
Hometown:
Buenos Aires, Argentina
Activity Feed
"well, now is better.
at least i get some readings
but always 4.9v.
i gotta measure the sonar output and compare.
if i disconnect, it jumps to 5v
Also i'll try to move the scaling factor to 1.4 (from 2.04), so i get the 5v=7m
hopefully is not…"
at least i get some readings
but always 4.9v.
i gotta measure the sonar output and compare.
if i disconnect, it jumps to 5v
Also i'll try to move the scaling factor to 1.4 (from 2.04), so i get the 5v=7m
hopefully is not…"
"No luck here :S"
"thx, i'll check it tonight and send feedback.
I have 3DR APM 2.6, what's your setup?"
I have 3DR APM 2.6, what's your setup?"
"Same here!
unfortunately no answer from any dev.
And release notes are not really clear about why was removed and if it's for both APM 1 and 2.
Not sure who ti ping."
unfortunately no answer from any dev.
And release notes are not really clear about why was removed and if it's for both APM 1 and 2.
Not sure who ti ping."
"Same here!
unfortunately no answer from any dev.
And release notes are not really clear about why was removed and if it's for both APM 1 and 2.
Not sure who ti ping."
unfortunately no answer from any dev.
And release notes are not really clear about why was removed and if it's for both APM 1 and 2.
Not sure who ti ping."
HiI have AMP 2.6 with Arducopter 2.3. I have Sonar MB1040 LV-MaxSonar-EZ4. it;'s connected in A0 with Signal in AN port of the sonar.but I can figure out how to get the "Sonar enable" checkbox "checkable", is always disabled. Sonar clicks if you put…
"thx man! worked perfectly"
"tried with 3rdradio config and RFDtools to reflash, but no luck.
any tip on any "low level" flash tool for this modem?"
any tip on any "low level" flash tool for this modem?"
"hi, i tried your 2.4 and the RFD 900 is not responding any more... not even the bootloader. Green light is alway on as if its connected to an other modem (and is not)
any clue?"
any clue?"
"any thoughts??"
Hi I was flying with ardupilot APM2.6 in drift mode. Battery still had 65% (4s 5amp)it went into a 2-3secs "radio blackout" and lost total control. Check the YT video: http://youtu.be/ORtLyxbpFwgIt seems it went into "Stabilize mode" when it flipped…
