Gender
Male
About
Location
nothern cape
About Me:
Director at EasiDRONE
Please tell us a bit about your UAV interest
Uav manufacturing, sales and service.
Hometown:
Kimberley
Activity Feed
"Thanks Francisco, I have done it like that but still loos control on ailerons when launch the plane."
"Hi Martin.
This is how it was as you explained and wiki. Thanks.
What I found is that when I have given TH aileron has no out put but does show movement in MP. Reboot at working again???"
This is how it was as you explained and wiki. Thanks.
What I found is that when I have given TH aileron has no out put but does show movement in MP. Reboot at working again???"
"I added the bin file."
"I got this from the wiki.
Tip:The green bars should move in the same direction as the transmitter sticks (except for Pitch where the bars move opposite to stick movements – low values are forward, high values are back). If the green bars move in…"
Tip:The green bars should move in the same direction as the transmitter sticks (except for Pitch where the bars move opposite to stick movements – low values are forward, high values are back). If the green bars move in…"
"Hi Benny, thanks for the reply man.
Yes I have a 5v 3A hobbywing ubec on the servo rail as redundancy input, coming to think about it I just checked and I also have my t motor esc red also going into the servo rail...this is probably not good."
Yes I have a 5v 3A hobbywing ubec on the servo rail as redundancy input, coming to think about it I just checked and I also have my t motor esc red also going into the servo rail...this is probably not good."
"But then it moves in the wrong direction."
"Nope just did that...I should only change it in mission planner so that right aileron has lower value."
"Nope its up....think you nailed it Andre...so in mission planner aileron is rev, I should then uncheck mission planner and then rev on tx. where can I find more about rev and pwn value so I can check the other channels. Thanks man :-)"
"Sorry I have attached bin file.
Yes like flying forward and upwards with roll left until facing nose down to the ground, if that makes sense.
Thank you for your reply Andre.61.BIN"
Yes like flying forward and upwards with roll left until facing nose down to the ground, if that makes sense.
Thank you for your reply Andre.61.BIN"
Hi guys hope this is the right place to post this. I am new to pixhawk and Adruplane, I have had a crash with my Skywalker using a pixhawk with fw 3.4. I checked the control surface in FBWA and manual and all was good, then launched the plane in…
Hi guys hope this is the right place to post this.I am new to pixhawk and Adruplane, I have had a crash with my Skywalker using a pixhawk with fw 3.4.I checked the control surface in FBWA and manual and all was good, then launched the plane in…
"Anyone????"
Hi guys hope this is the right place to post this.I am new to pixhawk and Adruplane, I have had a crash with my Skywalker using a pixhawk with fw 3.4.I checked the control surface in FBWA and manual and all was good, then launched the plane in…
"Yes I agree and from my side as well, I have been using other brands systems for more than a year now and I am very new to this open source fw and most of the time I dont know what I am reading Lol, but the amount of work and dedication is obvious…"
"here we go.2014-10-21 15-36-40.log"
"Sorry load wrong file before."
