Gender
Male
About
Location
Lexington, KY
About Me:
Been flying RC Fixed wing for 20 years, Helicopters for a couple
Please tell us a bit about your UAV interest
Just getting the bug!!!!
Hometown:
Lexington, KY
Activity Feed
"Also looking for this option."
"Using a pixhawk I have a dsmx sat connected to the board. If I bind thru mission planner it will only do dsm2. I can bind a sat to a rx then move it to the controller but the max # of Chanel's I get is 8."
Also tried to bind to a dx18 but only see 7 channels working. I tried using the instructions at the bottom of pagehttps://pixhawk.org/peripherals/radi...l/spektrum_dsm, still no luck
Guys I have the latest firmware on and having throttle issues. It's lagging by a second. Give it throttle and it takes a second for the blades to start, same thing when i kill it, the spin a second after.
"I have MinimOSD Extra Copter 2.2.hex installed. Running from telem1 port I have a 3dradio in telm2 When mission planner connected i can see voltage and amp from my pixhawk. Looking at osd it reports 0 for both along with some of the other…"
"Well I replaced the part on mine. $1.40 plus shipping for part. not easy at all to replace due to the size. I now have the 3.3 volts across, but still having the issue. "
"hey guys I have the 2.5 board, that will not connect to mp. i check and i'm getting 4.7 volts out of my chip. I assume this is bad...."
