I'm getting ready to run some of the individual tests in the Test Suite and had a couple questions before I actually start. My configuaration is as follows:ArduPilot code 2.6.2Shield V2UbloxX,Y & Z sensors The manual online states the following: The…

I just successfully loaded code base 2.6.2 for ArduPilot and when I attempt to power up the AP only get a red light and the blue GPS light never comes on, doesn't blink or anything. The GPS light did start blinking after the code was successfully…

I have assembled the main board (328) and expansion board (shield) and connected them together. With the GPS attached to the expansion board I am unable to load the code (v2.2.2) from the IDE (Arduino v0016). I am only able to load the code if I…

I have noticed that several posts discussing different capabilities seem to use the same pin locations on the main board (e.g. ArduPilot Shield and wireless telemetery).If a configuration utilizes the ArduPilot Shield can the system still support…