I'm getting ready to run some of the individual tests in the Test Suite and had a couple questions before I actually start.
My configuaration is as follows:
ArduPilot code 2.6.2
Shield V2
Ublox
X,Y & Z sensors
The manual online states the following:
The
Read more…I just successfully loaded code base 2.6.2 for ArduPilot and when I attempt to power up the AP only get a red light and the blue GPS light never comes on, doesn't blink or anything.
The GPS light did start blinking after the code was successfully loa
Read more…I have assembled the main board (328) and expansion board (shield) and connected them together. With the GPS attached to the expansion board I am unable to load the code (v2.2.2) from the IDE (Arduino v0016). I am only able to load the code if I remo
Read more…I have noticed that several posts discussing different capabilities seem to use the same pin locations on the main board (e.g. ArduPilot Shield and wireless telemetery).If a configuration utilizes the ArduPilot Shield can the system still support wir
Read more…