Hi,
My pixhawk is showing a pre-arm error of No RC Receiver.
It's there.
I can calibrate radio, and, throttle down and to the right produce tones.
So it's there.
I've reinstalled firmware, checked my connections.
No joy.
Any ideas?
Read more…Failsafe, RTL. My Quad doesn't know if there's a tree in the way, or worse, a human.
Is anyone working on obstacle avoidance using LIDAR, SONAR, or feature recognition?
Wouldn't it be great if my quad could go around a tree?
Thoughts?
Read more…This post has been up for 2 weeks now and I've got no response.
I first put this in ESC's and Motors, then "Pixhawk", Am I doing something wrong?
Hoping someone can help. Took a month off from flying my Pixhawk 3DR Quad and now motors won't spin when
Read more…Hey,
I'm fully aware of the dangers of opening up a lipo.
I know that it might be safer to render it inert in saltwater and throw it away.
I understand that sometimes, charging a dead cell at 10mAh, might bring it back to life.
Any ideas on the best and
Read more…Just got a brand new APM 2.6.
It won't connect to terminal, initial setup/firmware install, or Mav link in Flight Data in latest MP. (updated today)
My com port sees the Mega 2560, but "no connection" anywhere.
When I first click connect in terminal, th
Read more…Strange... For the past few days now, anything I type into the Forum search field returns a blank!
I've set up my minimOSD as per the diagram below, and, my Transmitter, Camera all work fine, however, there is no overlay data from the APM through the minimOSD board.
When I first set up the configuration below, the minimOSD board showed a progress
Read more…Hey... Relative Newbie help, please.
Can't get my Camera Servo to work.
I've searched thru the forums and posts already.
I'm trying to set up my Camera tilt with the 3DR suppled camera gimble and servo.
I've plugged in the servo's signal wire to APM 11
Read more…Hey All,
I'm trying to figure out the setup for the 3 'longer' legs that came with my Quad Arducopter, and for use with the camera mount. Can't find instructions or a setup anywhere.
I've got 4 booms, a camera mount, yet only 3 'longer' legs.
Can any
Read more…Got a brand new, factory built, (and tested?) Arducopter.
I'm a seasoned RC flyer, I've set up the drone in the Mission planner, Uploaded 2.9.1 Quad firmware, Radio calibration is correct.
Couldn't get the Automatic ESC Calibration, ESC's would beep c
Read more…