"Just to clarify, you can't have point-to-point communication between two 3G dongles. If you could do this, then one pair of 3G dongles could overload their respective cells and use all bandwidth available. Handled over IP shouldn't be any problem…"
"My problem was that I was using the Xaircraft X650 V4 and the ESCs it comes with. Those ESCs uses pulses from 0-1000us while virtually all the others use 1000-2000us as well as the APM2 so I ended up buying new ESCs which was in the correct range…"
I have a problem with my APM2 where it thinks it's -5 degrees when it's level. I've measured absolutely everything to make sure it's not my floors, my quad, my construction, etc. Just to show how much it is, I tried to take this picture to show how…
"I'm planning on a similar setup but with an USB cam instead of GoPro. How did you get the Cotton Candy? I tried pre-ordering but haven't heard anything so I'm waiting until end of June for a Raspberry Pi."
"Good point. They probably mean manned airborne platform but legally it might be conflicting. The FCC obviously only regulates the US, so it's hard to predict how the other countries' legislation are worded. I guess this would be illegal too then:…"
"Ah yes, Andy you're right about the USB slave. There are some that can be used if you have a newer Android but it's not a long term solution. http://developer.android.com/guide/topics/usb/host.html
(No edit function here? Had to delete my post to…"
"I should add that while I was writing my previous post and watching TV a lot of other posts where made so while I thought I was the first to mention linux PC mine seems a bit off. :)
Yes Andy, I saw that but it's your third goal while my main focus…"
"I'm working on a similar project but my goal is live IP streaming over 3g/4g. My path will be a bit different since I don't think they Arduino is a good platform for video-streaming. While using the APMv2 for the UAV operations, I'm thinking of…"
So I got a really newb question for you. I bought the 650v4 with ESCs and Motors but no flight controller as I assume that the APM2 could do the job. As I'm waiting for the APM2 I started looking at the connectors, but where on earth do I connect…