I have some strange behavior with my new build T960 on 3.3 RC4: Large oscillations on RCout but only on RCO5 and a bit less on RCO6 which suddenly stopped in this log. I am using Arris 5010 12 pole and BLHeli 13.2 with nearly stock settings (PWM high
Read more…Hi,
I did a post in the new forum, but I did not get any further response:
http://ardupilot.com/forum/viewtopic.php?f=21&t=5733
Craig said that Pixhawk with sonar works fine, but only if I define sonar pin (SONAR_PIN).
But this parameter is not avaliable
Read more…Hi,
did anyone changed the DGPS function to EGNOS instead of WAAS to get a higher GPS accuracy in Europe?
I thougt I should only change line 45 in AP_GPS_MTK16.cpp
"_port->print(WAAS_ON);"
to
"_port->print(EGNOS_ON);"
Did anyone tried it
Cheers Gregor
Read more…Hi,
having some problems setting up second aileron on RC5, I found another issue:
RCX_DZ parameters for the trim deadzone are always lost after reboot APM 2.
I used firmware 2.65 and 2.66 programming over MP.
Any ideas? I am sure that I reseted/erased AP
Read more…I guess I am right with it, that the APM now gets its trim values on every boot from RC. But if you don´t use an RC(Joystick or only MP) or its powerded off, thats not so fine. Can anyone confirm this "issue".
Regards
Gregor
Read more…Hi,
I own the APM 2 since 2 months build in a MPX Cularis, the plane is ready for fhe first flight, and short time before I updated to 2.60.
I use CH 5 for the second aileron and CH 6 and 7 for flaps in manual (RC6,7_FUNCTION 1).
But with 2.60 my CH 6 S
