About

Gender

Male


Location

Havre De Grace, MD


About Me:

Computer geek interested in jeeps, RC heli's, and anything outdoors.


Please tell us a bit about your UAV interest

Currently own a modded AR drone, a Blade 350 QX, Blade nano, a Horizon Delta-Ray (x2... One is firmly planted in an Oak tree), 3-or-4 3 channel coaxials, and a T-Rex 450XL (flybar). My interest peak and change daily however.


Hometown:

Havre De Grace


Activity Feed

Jason replied to David Strassman's discussion MinimOSD issue- No on screen overlay
"This is an old thread, but I have pertinent info to add.  I experienced the same issue as the OP but finally happened on my issue after reading through this thread and many sleepless nights.  Turns out my minimosd doesn't like my camera.  I have a…"
Aug 25, 2015
Jason commented on hector hind's blog post Micro APM Hardware "Just make it smaller.."
"@Quadzimodo When I referenced range I was replying to Richard and comparing apples to apples.  My comment was geared toward a full size UHF telemetry module that uses a rubber duck antenna (ie. the one that comes from…"
Jan 19, 2015
Jason commented on hector hind's blog post Micro APM Hardware "Just make it smaller.."
"@Richard  The PCB antenna definitely doesn't improve upon the range, but you have to remember what something like this is geared toward.  People eyeballing this are building 250 sized machines.  How far are you planning on flying your 250?  Anything…"
Jan 17, 2015
Jason replied to Todd's discussion Pixhawk on a DJI S900
"To the OP.  If you are anything like my you go on exploratory information hunts months before you start an actual build, which would mean that you are yet to make a purchase.  If that is the case, you can go ahead and throw the Tarot X6 in the mix.…"
Jan 5, 2015
Jason commented on Marius's blog post HOBBYWING Quatro 20Ax4 Esc with 3DR APM 2.6
"Your post was a godsend.  My quad was flipping uncontrollably before this.  I wish I had found this sooner.  Thanks for the configuration laydown."
Sep 9, 2014
Jason replied to Monroe King's discussion APM Repair Service
"I went the route of trying to do it all myself.  Ordered a frame, Motors, SC'S, BEC, APM, GPS,  MinimOSD, Fatshark system, Orange RX, batteries, and telemetry radio.  I have all of the physical parts, but no clue what right looks like so I can't…"
Mar 22, 2014
Jason replied to Monroe King's discussion APM Repair Service
"PM'ing now."
Mar 22, 2014
Jason replied to Monroe King's discussion APM Repair Service
"Can I just send you my entire quad for repair/tuning?"
Mar 21, 2014
Jason replied to Uttam's discussion kk2.0 Quad stabilization
"I'm having the same issue, and when I had my post on here I got the same amount of support that you have gotten.  Try over at RCGroups."
Mar 8, 2014
Jason replied to Aaron Pailthorp's discussion SK450 Dead Cat - PID tuning advice sought
"I had/have a similar issue with my KK2.1 controlling my deadcat (alien/reptile)  And I got the same amount of support that you have.  "
Mar 2, 2014