Gender
Male
About
Location
Newton, NC
About Me:
Hobby include QuadCopter Builds, R/C Trucks
Please tell us a bit about your UAV interest
Multi Copter Building
Hometown:
NC
Activity Feed
"Also, My GPS keeps moving when the copter is sitting still. Not sure why this is happening either."
"It is a stock DIY Drones 3DR. with 850 motors, 10" blades. 2650mah battery."
"I have button setup for stable, atl hold, auto.
"
"
"Copter, Only flown in Stable mode."
I am trying to get the mission planner to work. I have put in home position, and started with a take off to 20m. When I stwitch to auto mode and throttle up. the throttle goes a little but never a takeoff. What am I doing wrong. Does anyone…
"Ok. I've completely redone my quad. I purchased the 850 motors and 12" blades from DIY Drones and Its flying a little better. But I'm having trouble fine tuning. Does anyone have a good tuning method. I have read all I can but I can't seem to…"
"Any pointers on fine tuning the PID."
"2.2. Wasn't sure which one i should be using. I thought the battery would be ok, I tired flying with my 3s 2650mah batteries and it does the same thing."
"I tried some different motors and esc's and they work fine. But these Turnigy Trust don't beep unless I hook up the usb first then the battery. "
Ok, Got it flying today. But, need some help tuning. I have the DIY Drones 3DR Frame, with Turnigy D3548/5 900Kv motors, Turnigy Trust 45A BESC's, 10 x4.5 Blades from DIY Drones, and 8000mAh Zippy 4s battery. Total weight is 5.2 lbs. I get it in…
"Ok. This is real strange. I finally got it working. But here is the catch. I have to plug my APM board into the pc. wait a few seconds, then plug in the battery and then I get tones from the ESC's. I unplug the cable from the pc and it work. …"
"ok. I've tried that too. When I have the APM board hooked up to the pc and run throught everything. Then I start getting continous beeps from the esc. Not sure why that is happening either. But when I unhook the battery and hook it back up…"
"I am not sure how to do all of them at the same time. "
"Yes. I followed everything as it stated. I plug the battery in and no sounds coming form the esc. I get the light on the board and can arm the board, but still no motor response. I can get the motors working if I hook them staight into the…"
