About

Gender

Male


Location

Ostrava


About Me:

I want to see known places from the birds view :-)


Please tell us a bit about your UAV interest

Arducopter, FPV EasyStar


Activity Feed

Jiri posted a discussion
Hi,I have successfullly built Arducopter, made couple test flights and realized it is better to go hexa or octo, I plan to do "serious" SLR photography.I was looking for PDBs schemes / DXFs / PDFs and didnt find any, so I bought one and here is 600…
Dec 10, 2011
Jiri commented on Jani Hirvinen's blog post ArduCopter GoPro Mount, 2-Axis from ArduCopter factory @ jDrones
"Honestly, this looks like a copy. And 45 dollars is too much for me, provided servos are not included.
 
So ... ARE THERE ANY "SOURCE DESIGN FILES" available for download?
 
I was also looking for HexaCopter Main frame plate and power distribution…"
Nov 28, 2011
Jiri commented on Felix Meissner's blog post setting up 6 different flight modes on a Spektrum DX7 using just one channel
"Tried this, was not working for me (only two modes with GEAR switch were working) and then I found out I had to swap GEAR and AUX1 cables on my AR7000 receiver.
Now works perfectly.
Thanks !!!"
Nov 17, 2011
Jiri replied to Sian-Jie Ciou's discussion Can RC gear and XBee use 2.4Ghz both?
"I have the same problem and here is what I googled
 
Yes, there is no frequency conflict. Last summer while testing Spectrum with 6200 RX the plane went out of TX range and went down about 2/3 mile from launch. We still got GPS track w/Delorme which…"
Nov 14, 2011
Jiri replied to Jiri's discussion APMSetup does't work - "Missing RC rev Param" message in Radio Input
"SOLVED !!!!
 
Shame shame shame on me :-(
 
For whatever reason (well for sure this happened because I was so eager to see my Arducopter in the air) I forgot to solder 2 pins (PG0 and PG1) to ArduPilot Mega board ...
 
Anyways, many thanks to…"
Nov 8, 2011
Jiri posted a discussion
Hello everybody, newbie here, I am facing problem I couldn't solve during 18 hours spent over arducopter, so really frustrating. I soldered everything together, doublechecked, measured with multimeter, resoldered all pins just to make sure again ...…
Nov 3, 2011