Gender
Male
About
Location
Portland, OR
About Me:
Photo/video guy in Portland, OR
Please tell us a bit about your UAV interest
Just getting started!
Activity Feed
"Ever get an answer to this? I'm looking for options but this may be the best right now? Thx!
-joe"
-joe"
"OK, after re-reading the entire troubleshooting section, rebooting my computer and re-uploading the firmware, I'm back up and running. Any clue as to why just changing a lipo put the APM in a funky state? Thanks, and I'll try not to panic so hard…"
Hi there! I'm quite new here, so here's what I've done so far. I successfully uploaded firmware initially and configured my 3DR quad fully. I had a few successful flights which were great and then upon changing lipos today, the quad stopped…
Forgive the newbie question but I'm a bit confused on how to hook up this receiver to my apm2. I have the Hitec Aurora 9 Tx and purchased it with the Optima 7 Rx. The Optima appears to have male pins, but I think that where it wants to plug into…
"What gimbals are people using for the GoPro, if any? I'm completing my 3DR quad build and want to make it into an aerial photo platform... Thanks!
-joe"
-joe"
"Bump? 3DR mount anyone? Thanks!
-joe"
-joe"
"I'm also looking for this, with the possibility of tilt/roll. Minimal vibration will be key. What do people use?
Cheers,
-joe"
Cheers,
-joe"
"Looking for the same thing, did you find a solution? I'm building a 3DR quad right now and want to have a GoPro mounted on it, preferably one that is 2 axis.
I want to have the APM balance out the motion of the quad with the mount, and have the…"
I want to have the APM balance out the motion of the quad with the mount, and have the…"
So, I'm finally building a 3DR quad after months of reading up and educating myself and I remember seeing advice to use CA (super) glue or locktite for certain bolts. The online instructions don't mention it, so I must have seen it in a forum…
