Anyone had a problem with this camera, where the video signal comes through without the digital overlay? But then when I jiggle the camera - I have no video signal but I CAN see the digital readout of the OSD. Problem is I can't get both the digita
Read more…I was out today flying in Manual, Stabilize, RTL and Auto mode today and evertything started out OK. The Auto mission had 7 way points and a home location. The altitude of each way point is 100 meters. I started out in manual and when I reached ab
Read more…I have APM 2.5, MinimOSD 1.1, Fatshark transmitter with a low pass filter for the battery connection. I configured the placement of gauges to my liking and they are showing up correctly. I'm getting a 0 to -.1 amp reading in the current meter on th
Read more…When I power up my APM 2.5 board (via USB port) with no peripherals connected everything is fine. When I add the 3DR Radio the board still powers up correctly using the USB port. When I connect the Ublox LEA-6H board and then add power via USB, the
Read more…I have found discussions in the forums about XBee radios, 9x receivers and er9x firmware, but none on 3DR radios. Has anyone combined the er9x on the Turnigy transmitter with 3DR radio to acquire telemetry data? Is there a tutorial to follow? I h
Read more…I had a really bad misconception about what I would need to monitor my bixler from the ground once I had configured the 3R Radios. I thought that I could just use the radios and a laptop (via mission planner) to do that. Can someone send a reply (o
Read more…OK the radio plugged into the USB port and the radio connected to the APM are both showing solid green LED's. I guess that means they have discovered each other. I have the baud rate set to 57600 in the MP software. Problem is I get the, "Failed
A "hard landing" has made the MediaTek GPS separate from the APM2 shield. The blue led no longer flashes on startup and I cannot use Live Calibration on the compass (it shows that I'm off the coast of West Africa, instead of in PHX, AZ). Can anyo
Read more…I have downloaded and updated APM PLanner 1.1.97. Plugged in the board using the USB cable and it's not getting any power. Don't know if the cable is bad or the board is fried. Can anyone point me to a troubleshooting page?
Read more…