Gender
Male
About
Location
Madrid
About Me:
I'm build a Quadripocter with Arduimu v2 flat
Please tell us a bit about your UAV interest
Arduimu V2 flat
Activity Feed
"Hi Lenz, I load the Jose Julio´s code (ver 1.15), but i think my problem is because in JR the order channels is 1 throtle 2 aileron 3 elevator and 4 ruder, and I can not change the order they are read, and the times of each in the chain."
"After loading the 1.7 code so good on the test, but when I test the board in the quad does nothing. My radio is JR with 2.4 module FRSKY DJT and receiver of FRSKY D8R v2 with PPM sum on channel 8 (updated).
I think the problem may be because in JR…"
I think the problem may be because in JR…"
"Fixed. The FTDI cable was wrong. I have seen this to make a FTDI cable with that if it worked my plate. You can see how it is here: http://txapuzas.blogspot.com/2010/07/cable-de-programacion-para-ard...
The construction cost is about 5$."
The construction cost is about 5$."
I'm new to the Quad, and I would appreciate help.I have V2 ArduIMU flat and I can not load the code. At first I could do it, (use Diydrones cable) and I tried several versions (1.5 1.6 1.7) and even worked the ArduimuTest then when connected to the…
Hi, I'm doing a ArduIMU quadcopter with V2. I load Arduimu code without problems and HappyKillmore ArduimuTest is fine, but when I try the plate with a servo and transmitter receiver does nothing, no move to move the plate, and even when I move the…
