Gender
Male
About
About Me:
I have been aktive flying modelplanes and helicopters for some years and is memer of a lokal rc-club.
Please tell us a bit about your UAV interest
I like the combination of flying programming and make video and pictures in our nature. At the moment I have a QUAD / Arducopter APM 2.5 and Go Pro. Allready done some lokal auto missions. I am aiming for a Pixhawk controller in my next projekt
Hometown:
naestved
Activity Feed
"I have this Log Files where one of the lines says:
Test: IMU Mismatch = NA -
Everything else but the IMU says GOOD
-----------------------------------
Log File C:/Users/Kim/AppData/Local/Temp/tmp2DBA.tmp.log
Size (kb) 446.115234375
No of lines 6564…"
Test: IMU Mismatch = NA -
Everything else but the IMU says GOOD
-----------------------------------
Log File C:/Users/Kim/AppData/Local/Temp/tmp2DBA.tmp.log
Size (kb) 446.115234375
No of lines 6564…"
"Thank you very much for your help. I will try to find a log file"
"Thanks :-) Yes I got the meaning - but first after I wrote my ansver ;-)
By the Way - I use attopilot 90 A combined with BECimage.jpg"
By the Way - I use attopilot 90 A combined with BECimage.jpg"
"Tried shorting the PM input. It seemed to work out. At least I got rid of the gyro warning 2 out of 5 times, but it is unfortunatily not consistent and safe for Flight.
For information I use the attopilot 90A (using 6S LiPo) combined with a Castle…"
For information I use the attopilot 90A (using 6S LiPo) combined with a Castle…"
"Thanks for the suggestion. I will see if it is posible to shorten the PM input a bit more."
"Thank you very much for the information :)
I bought it at the 3DROBOTICS a month ago and it just came out of the box this weekend."
I bought it at the 3DROBOTICS a month ago and it just came out of the box this weekend."
"This weekend I finished building my new Quad. I have used a brand new 3DR Pixhawk (not a clone).
I get following messages : Accells inconsistent og just Bad Gyro Health.
Tried to load previous firmware V 3.1.5 and later again V 3.2.1 with the same…"
I get following messages : Accells inconsistent og just Bad Gyro Health.
Tried to load previous firmware V 3.1.5 and later again V 3.2.1 with the same…"
"I have recently experienced the same problem on my Quad with my minimosd v.1,1 going on and off. Sommetider it does't work at all. The picture from fpv camera is stable - so nothing to do with the Tx. Sometimes it helps to reboot the minimosd.
It…"
It…"
