Hi,
I'm having issues with my PX4-based quad. I get it armed and motors spin normally, they are all in the correct order since I get it off the ground more or less smoothly. I can get it off the ground and move it back and forth, left or right with so
Read more…Last saturday I went to do some testing on my quad and I had an awful crash, this is what happend:
- Armed the quad with Mission Planner in Stabilize mode
- Moved the a few meters up and a few mts away south
- Switched to RTL
Then the quad went to the no
Read more…Hi,
I have setup a quad like this:
APM 2.6 fw 3.2.1
3DR 915Mhz Radio
3DR GPS
3DR Power module
HJ 450 Frame
Also use APM 2.0 RC1/RC3
I flew it normally for a time, I cant figure out why at one moment it started to behave really odd, I think it was when I was
Read more…Seems that if I want to make the drone to autonomously take off I cannot do it because the APM waits for the speed to be greater than a few m/s to actually start doing anything, in this case start to steer the UAV.
Using Mission Planner how do I make
Read more…Is it possible to use MP with mavlink and no radio control equipment?
cheers
Read more…Im using MP 2.0 RC1 and APM 2.6 Quadcopter,
I can't get to even move the engines doing a test with the serial console, they beep when I turn them on I beleive normally.
I don't have a RC transmitter/receiver since it's not really important to my projec
Read more…I'm using MP2.0.0 (RC1) and the Joystick button is not showing up in the Actions Tab, I have a 3DR data link working perfectly.
Is the support for it included with the RC1 APM planner version?
I'm running this on Ubuntu 12.04 x64
Cheers
Luis
Read more…I been reading a lot about how crappy is the ar.drone, but at the moment I have one and I have an APM 2.6. While my proper UAV gets to the country (that will take about 2 months) I can can work on getting used to the APM software side.
My current pro
Read more…