Marc's Discussions (41)

Sort by

APM 2.6 Logging fault

Hello all,

Weird problem with the logging everything else works, logging problem is:

the cli will not respond unless I have a separate power to the APM with the usb cable power as well.

when cli responds I go to log download and it starts then just hang

Read more…

Too much Turn help

Hello all,

Have a slight problem I cant fathom apm height and speed brilliant!!! but if I go from one way point to another having to turn 180 degrees the plane always overdoes it by turning 270 degrees which then puts it way out for the next waypoint,

Read more…

Overlay

Has anyone managed to get the kml overlay working, as I want to see my waypoint file then overlay the mission log to see how close the flight was, but tried kml overlay but doesn't work, any thoughts anyone.

 

regards

 

Read more…

Fault found

Hello all,

A definite fault in the code, when entering auto mode via mission reset when the plane is above your desired altitude the plane will go to high throttle and nose down and will not pull out unless you go back to manual, however if you missio

Read more…

Level

I noticed someone else posted this earlier there is no option to calibrate level in the mission planner screen, looks like this has to be done direct from the CLI, does this mean this will not be available via the normal way on mission planner? or wa

Read more…

Arducopter V3.01

Err hello all I may have lost the plot here but cant get any output to motors on my hex from channels 5 and 6 if I move them to 3 and 4 all is ok so motors and escs are fine?

 

Any thoughts or is the heat getting to me :)

 

 

Read more…

Altitude

Hello all,

In previous firmware there was a option to pick GPS or Barometer or both for altitude control I have noticed in the new firmware this has now been removed, does anyone know how altitude is now controlled in the code GPS, BAROMETER or both?

 

Read more…

RST_MISSION

Hello All,

In arduplane you can set RST_MISSION on a pwm value allowing you to reset the mission in flight, can this be done in arducopter? as there is no rst_mission in advanced parameters.

regards

Read more…

PX4

Hello everyone,

decided to start this for a place we can talk about the PX4 I personally have got it loaded with firmware and connected to the mission planner but cant get it working with sbus and I hear there are problems with the 8ch ppm encoder boa

Read more…

PX4 - SBUS

Has anyone here used the px4 board with futaba sbus system yet, would love to hear from anyone as im stuck scratching my head.

regards

Read more…