Gender
Male
About
Location
Waterford, Ontario
About Me:
From Canada, if it's less then 35kg it's OK...
Please tell us a bit about your UAV interest
Quad Camera Platform with Long Range FPV. Quad FPV Racer Ground Off-Road Long Range FPV buggy. I love the whole out-of-body experience...
Hometown:
Waterford
Activity Feed
"I pull the C-clips on my downward facing motors. This way I can just pull off the tops of the motors and props with them for transport. Also allows for cleaning of iron grit that the magnets can pick up."
"I've built three lawnmowers (Down Facing Motors) and have had good success. I like downward as I pull the retaining clips on the motor shafts allowing me to be able to pull the tops of the motors off with the propellers still attached. Great for…"
"I'm Using a Print-Rite, $300 USD from hobbyking.com 210x210 non headed print bed. I do my modelling in Blender, (1 BU (Blender Unit) = 1mm). I slice using an upgraded version of the supplied Repieter-Host software. It's been fantastic once you…"
"So realizing that this hobby was going to be taxing my paychecks anyways, I purchased a 3D printer to save in the long run. 2 More drones using the same hardware as above, but with a battery tray designed to use either a 2200mAh Li-Po or a 5200mAh…"
"The crash was caused due to the fact I didn't factory reset my Naze32 before using it. Everyone using the great Naze32, factory reset it before first use. Some of them have an odd bug fixed by resetting them when shipped."
"R.I.P. Mini Drone. At about 600 meters she started to oscillate then went into an uncontrollable free fall. I think one of the carbon fiber props either came apart or became unbalanced. Damage: Video transmitter, FPV camera lens, 3 props, screen on…"
"Kids, Math Matters... So I got my parts in and got her assembled. Jumps off of the ground at about 40% throttle, and very gently flew for a little over 30 minutes before I got worried the low battery alarm wasn't working. Tested it and the 5200mAh…"
"Yah, that's kind of my biggest fear. The battery will be strapped to the bottom instead of the landing gear, so size really isn't as big an issue as weight. All up weight should be 730g, and my calculated max thrust should be close 1600g (Hoping),…"
"Just Ordered My Hardware For My New Mini FPV:-Hobbyking™ S250 FPV Racer Composite Kit 210mm-AfroFlight Naze32 Acro AbuseMark-HobbyKing Tiny OSD III (w/10Hz GPS and 80A Current sensor)-Multistar Elite 2204-2300KV Set Of 4 CW/CCW (2/CCW 2/CW)-TURNIGY…"
