hi all again :)
i am getting a lot of servo jitter on my middle switch. i have them setup as
#define POSITION_1 MANUAL
#define POSITION_2 STABILIZE
#define POSITION_3 FLY_BY_WIRE_A
manual is fine, rock solid
i get a lot of constant jitter and twitch on s
another newbie question.
i am getting the following lights on the boards;
IMU
solid orange, occasionally drop out then back solid
Solid blue, again occasionaly drop out then back solid, GPS lock after a couple of mins
no red but when i move the IMU aroun
i am trying to conduct the tests before i fly my skywalker.
i have test flown my plane without any gear and have now just installed all the ardupilot.
on the test page http://code.google.com/p/ardupilot/wiki/Test
i have tried inputting 1 into my arudpil
hello all,
i am just setting up my ardupilot and i have some questions (maybe a dumb one)
1) ardupilot takes the throttle, ailerons and elevator. is it possible to plug a rudder and pan and tilt direct to the receiver ?
will this have an effect on the
i wired it up and there is no picture coming out.
i have wired it with white (video out) to yellow (video in) and yellow to white and i have
tried crossing them like the wire diagram says and still nothing.
i connected our dvd player to the 4" media pl
hey,
my friend is helping me setup up my Ardu gear for me. We are having a few teething problems.
We programmed the Autopilot and I finally got it done with the 2.5.1 code. I'm still having trouble programming the IMU and can’t find any tutorial any
Read more…hi all i am currently trying to buy my first setup.
i am trying to purchase the ArduPilot Shield V2 Kit, but when i add to cart it says the servo extentions are not in stock.
but if you go to the cables/connectors tab they are availible.
i tried look
Read more…