With the original schematic (Power from Pixhawk to 'Vcc' I get fluctuating Rx voltage display. I get much better results by powering the Arduino from the Rx (Rx on 2s). Red wire goes to 'RAW' and NOT to 'Vcc' !!! Signal (white /…"
"Thank you for your testing with MC series RC which I don't have.
I use this with my pixhawk's latest FW with no problems.
Newer version will use better-written 1-wire serial port, but it's not ready yet.
Will be glad to hear form you."
"There is a patch for HoTT protocol support by Adam Majerczyk
I'm using HoTT for two years with APM and with PX.
Also there are some MAVLink2HoTT translators. I made one of them. It's firmware for Arduino micro etc. You can easily find it within…"
"Hi,
"I want it all and I want it now" approach won't suit here.You should think definitely what alerts do you need and how these alerts are to be displayed.
Please note that MX20 sensor data pages layouts you're using are pre-defined by Graupner…"
"Hi pix,
Yes I developed this code based on Adam Majerczyk's and MinimOSD code.
I plan to share it, but nowadays it doesn't look good enough.
What features exactly do you need?
In fact it's possible to display a string of text at the bottom of MX-20…"
Hi,I'm switching form APM to Pixhawk now and I'm surprised with GPS troubles. Any of 2 GPS modules I have (one with compass, other without) work fine with APM or connected to PC, but when connected to PX indoors HUD shows "No GPS" instead of "No…