Gender
Male
About
Location
Wailuku, HI
Please tell us a bit about your UAV interest
Hobby, beginner
Hometown:
Maui, Hawaii
Activity Feed
"Anyone have any ideas? It looks like that esc is not responding to the throttle signal from the apm... No matter what port I plug it into (1-6) but it responds to a rx signal just fine... I tried lowering the rc_speed rate and no change…"
"Thanks, I tried that a few times. it works fine when not connected to the apm..."
So, I'm building a new hex. Got it all wired up, programmed the esc's, did all the calibration stuff. Motor 6 won't start on the APM. Feels like the brake is on. Connected that motor directly to the ch3 of an RX and it works just fine. Back to…
"Hi, I'm a little stuck with the auto tune. I get roll corrections for about 6 minutes, then my low voltage alarm goes off and I have to land. How can I get a good auto tune with 7 minute flight times? Is there a way to split the roll and pitch…"
"Love the new version! No more issues for me on the copter, everything is good and workable. I do get a high v speed warning though all the time, even when sitting on the ground. I'll have to check my settings. Thanks for the hard work…"
"Sorry, little confused. I'm looking to download a stable release. It says 2.1 is stable, but there is no 2.1 in the downloads, and 2.2 copter locks up on me all the time :( Help? Thanks :)"
"Do you seriously have to have the amp plugged into usb to do the compasMot Setup!!!??? Is there no other way to do it via telemetry or a special setting? Thanks,
Nate"
Nate"
"Yes, newest arducopter :( Thanks for checking. I'd love to be able to tune wirelessly and use my fpv osd."
"Me too. set the params as listed, no osd communication unless i connect to the 3dr radio first... I rebooted, and the params are still there, but no luck. Any help? Thanks,"
"Any updates on this, I just did the same thing!!!"
