Gender
Male
About
Location
Pattaya,Chonburi
About Me:
I live in Pattaya Thailand . interests AP , Freestyle jet skiing, Off road motorcycling.
Please tell us a bit about your UAV interest
I am interested in building a multicopter for AP work and general flying.
Hometown:
Steyning England
Activity Feed
"When I engage alt hold at 1 m it holds ok but when i try to climb a bit then return the stick to center it continues to climb.
If I the come out of alt hold climb a bit and let it settle then engagae again it drops and hold at 1m again !
In loiter…"
If I the come out of alt hold climb a bit and let it settle then engagae again it drops and hold at 1m again !
In loiter…"
Hi, I am quite new to the arducopter project. I have flown traditional helis for 15 yrs so have a grasp of rc.I have built an arducopter to carry my AP camera.I am quite disapointed with the general stability of it .I have the uprated motors from…
This is what I found . The Spectrum radio seems to be very similar to the JR. the PWM values needed are here, the centre ones are what I came up with.Flight Mode # -- Min. PWM -- Ideal PWM -- Max. PWM#5 -- 1750 -- 1763 -- >1815#4 -- 1620 -- 1683 --…
"I have done it !
This is what I found . The Spectrum radio seems to be very similar to the JR. the PWM values needed are here, the centre ones are what I came up with.
Flight Mode # -- Min. PWM -- Ideal PWM -- Max. PWM…"
This is what I found . The Spectrum radio seems to be very similar to the JR. the PWM values needed are here, the centre ones are what I came up with.
Flight Mode # -- Min. PWM -- Ideal PWM -- Max. PWM…"
I have been told that no. 5 and 6 outs on the apm board will stabilise a camera mount pitch and roll axis. My question is how do I enable them as at present they dont power up the servos ? Br Nick
"Sorry I just realised I posted that in the wrong place ! How do I remove it? It did not give me the chance to edit ?"
"Would it work if I turn the board round through 180 degrees leaving the magnetometer where it is and reversed the ail ,elev and rudder channels in the transmitter ?
Having checked again the rudder compensation is correct but the stick is reversed.…"
Having checked again the rudder compensation is correct but the stick is reversed.…"
Hi,I have just built an arducopter and I am now trying to set it up.I have connected everthing as instructed, checked it all many times I first tried to use the APM planner , It connects OK I have been through first time set up in firmware section…
Hi, I am about to buy a new laptop to run my APM planner and was wondering if it will run OK on windows 7 ? And do you recomend windows 7 rather than sticking with XP ? Thanks Nick Wadman
I have downloaded APM Planner to my PC and it is working well, but I have dowmloaded it to 'downloads' on my laptop Unziped the files , when I try to open the programe it says; 'The application failed to initialise properly (0xxc0000135) I have…
