"Well you should not have the jumper installed if you have a 3DR power module.
In the fail safe menu, look to see if your pwm values change when you are armed (without props) and move the sticks around look to see if they correspond correctly."
"Ok so I flew it today and it still flipped but it did gain some air first.(In stabilized mode) (Unfortunately, when I reset the APM Board I forgot to put nearly all for the Log)
I tried to fly it again but this time in acro mode, but it still…"
"Thank you guys for your responses.
I have reset the APM and Done everything above. I have checked the Trims and they were all on 0. I will fly it Tomorrow and see if it flies correctly."
"i have two of them in parallel.
I lift the throttle less than a quarter of the way and it starts to lift so i think it should be fine.
If I need to I can just use one battery."
"How do I change the Logging value?
What should I change it to so that you get the information?
I also did do a auto tune (before that log) while it remained stationary on the ground with no props. Does that have to do anything with it?(It still…"
"Michael Burmeister said:
There is a couple of things that may cause this. Since you were able to arm and start to takeoff there is a flight log on the controller that we would like to see. It will tell us what version of software you are running…"
I am brand new to drones and aircraft.I have done robotics for about 5 years though.My drone keeps flipping on liftoff.I have seen that many people recommend to Check the motor direction and the blades.(I have done this over 20 times)I have set the…