Gender
Male
About
About Me:
Rapid Protoryper/model aircraft/drone pilot
Please tell us a bit about your UAV interest
Funflying, Research, Competition
Hometown:
Aalborg
Activity Feed
"I agree. However if available gimbals only provide the above: PPM/SBUS etc. is there a way to achieve that?"
I have been searching high and low (I believe) for information on how to connect an control high end gimbals for DSLR cameras that only support PPM/SBUS/Canbus etc. for example: https://www.gremsy.com/gremsy-h7I need to be able to control the gimbal…
"Unfortunately not. I am kinda stuck. I have made the HW setup as show for the Arduino with multiple sensors. But I have no idea how to make the pixhawk address the 3 different sensors (I guess they have the same HW id?) because I can only get one to…"
"Thanks, I have just reached out to Randy.
/peter"
/peter"
Hi there.I am in process of setting up a quad that need to fly with 3 Lidar lites in a circular array.See example here:I know how to wire up 1 sensor to the pixhawk, but I don't know how to add 3, and how to setup them up in mission planner.I hope…
"Can anyone please tell me what gimbal this is:Thanks ;-)"
"How would the diagram look for connecting 3 LIDAR-Lite V2 to a pixhawk?
If anyone has an idea to the code needed for this to work, I would be forever grateful ;-)
/peter"
If anyone has an idea to the code needed for this to work, I would be forever grateful ;-)
/peter"
"Do you know if it will be possible to use for example 3 liar sensors to the pixhawk or similar?The reason I am asking is because it is not clear to me if this is possible? And it is quite expensive to purchase 3 of them, especially if they can't be…"
"Hi George.
The platform should avoid touching the sides of the pipe.
We are actually testing the skewed motor tilts in the coming days. However I would still like to find out what proximity sensors would be best, and the FC.
Thanks, Peter"
The platform should avoid touching the sides of the pipe.
We are actually testing the skewed motor tilts in the coming days. However I would still like to find out what proximity sensors would be best, and the FC.
Thanks, Peter"
"Thanks, Andre
In your opinion, are there better sensors than Lidar for close proximity use? The distance in this case from sensor to surface will be ~15-20 cm
thx
/peter"
In your opinion, are there better sensors than Lidar for close proximity use? The distance in this case from sensor to surface will be ~15-20 cm
thx
/peter"
"Hi Andre
Thank you for the answer.
Do you know if it is possible to use 3 lidar sensors on for example the pixhawk? Or is there better fc's for this?
/Peter"
Thank you for the answer.
Do you know if it is possible to use 3 lidar sensors on for example the pixhawk? Or is there better fc's for this?
/Peter"
HiI need some input for solving a "problem" with flying a multirotor in a tube (dont ask why ;-) )When flying manually in a tube/pipe with relatively short distance from propellars til the tube-wall there seems to be a vacuum spot in the center of…
