can some one help me with those issue pls ?
arducopter 3.3.3 / pixhawk
after
msg11.target_system=1;
msg11.custom_mode=4;
msg11.base_mode=MAV_MODE_FLAG_CUSTOM_MODE_ENABLED;
mavlink_msg_set_mode_encode(1,1,&buff,&msg11);
mavlink_finalize_message(&
pleas can some one tell me what is hanshake message for continue acc calibratinon to next step ?
detailed:
im sending long comand (msg 76 ) id 241 0,0,0,0,1,0,0 for start calibration routine.
then APM send me " place vehicle level and press any key" tha
Read more…Hello .
I have very strange problem with chanels. I looking for some logic result 3 days and no succes , so im writing here ;-) im using APM2.6 and ac 3.2.1
When i instal firmware, clear ( default ) , mission planer chow me in RC CALIBRATION that chane
Read more…Hi all.
im working on new gs software. I`m working on it becouse its connected with project WOD,
but this part is not ready for public,so i will present it later :D
but please you can help me , if you will write me here or to email p.cz@seznam.cz FEATU
Read more…