I'm having a bit of a problem with my quadcopter controlled by APM3.2; sometimes motors stop spinning mid-air and quad drops dead on the ground.
I'm trying to find the cause but have curiously found out that no logs are present. I've dug deeper and fo
Read more…The thing is I crashed the other day and the battery with leads was torn off the back of the GPS. The result is that now I have to wait a few minutes for GPS fix. If someone could kindly share how the battery was mounted on originally I would be very
Read more…I've bought propellers from RCTimer (http://www.rctimer.com/product_638.html). There are 12 pairs of CW and CCW propellers. On half of them there is an adittional label "R". Does this stand for "reversed" (CCW)? I couldn't find an answer anywhere whi
Read more…Hey guys,
I'd like not only to power the LEDs using LiPo but also make them blink. I though I need to connect them to APM's output rails and program APM for them to blink. Stripes are these from HobbyKing.
Is this possible and if yes does anyone have
Read more…**NEW FINDINGS**:
I disconnected every cable from receiver and hooked up a servo (and power of course) to check if I get any response. Turns out I can't even move servo using Rx/Tx! I can hear servos when they are first plugged in though.
If I turn off
Read more…Hey guys,
I have this UBEC and the Arduflyer. The connector on UBEC is 2-pinned, but the PWR connector on ArduFlyer is 6-pinned. Can someone elaborate how this is supposed to be put together? :)
