Gender
Male
About
Please tell us a bit about your UAV interest
Any scratch build and low cost with thingkering will do. More fun.
Hometown:
Jakarta
Activity Feed
"My F550 flew really well with Stock AC 3.1 PID. I didnt even need to tune the PID if i were lazy.
If you having problem with PID setting please try AutoTune. "
If you having problem with PID setting please try AutoTune. "
"Thanks Flew around 5 times this weekend, everything seems perfect. I was afraid that my APM will brown-out and reset mid air, so this certainly avoid the problem. I happy that i catches this problem before its happened."
I have been adding minimosd, 433mhz telemetry, a single servo for gimbal pitch stabilization.I connect the servo positive and ground to one of the ESC BEC for power and connect signal to RC11 on APM.I noticed that the receiver voltage went down to…
"funny think is still cant find drift on the drop down list. "
"My Hexa behaves exactly the same it wants to roll or pitch in small amount like random when there are even small air movement but will perfectly hover with no input when wind is non existent. I used to have this problem on my Multiwii because of the…"
"Yes my hexa does same it bounces back a few degree back after you release the yaw stick. i have not been able to solve this either. "
"I am using the latest Mission planner and Running AC 3.1 but cant find Drift mode ? anyone can help?
http://diydrones.com/forum/topics/where-is-drift-mode"
http://diydrones.com/forum/topics/where-is-drift-mode"
Can anyone be so kind which one is drift mode?I am Running Arducopter 3.1, cant seems to find it anywhere.
"Tried Auto Tune Today.
Frame DJI 550, Multistar 2216 800kv, 4S 6000mah, 10x47 Carbon Mixed Slowfly.
After tuning, my hexa feels loose and mushy, probably because of the low P roll value. My previous PID was using APM Default it flew better. "
Frame DJI 550, Multistar 2216 800kv, 4S 6000mah, 10x47 Carbon Mixed Slowfly.
After tuning, my hexa feels loose and mushy, probably because of the low P roll value. My previous PID was using APM Default it flew better. "
Hi, I am running AC 3.1 RC7 on DJI Flamewheel 550.Every time my Hexa Yaw hard with full cyclic and release there is a sudden throttle jump which results in increased altitude. I have rate YAW P(0.35), I(0.06), D(0). I am sure this is just a PID…
Hello, How do i switch/swap input Channel 5 to channel 7 or any other channel while using PPM Input on Arducopter?Best Regards.Rizki
"Anyone?
I changed to stiffer carbon prop to no avail as well as changing to smaller 9x47 prop also no change in behavior. If money permitting i would probably built a new aluminium hexa frame as the DJI flamewheel arms i suspect could be too soft…"
I changed to stiffer carbon prop to no avail as well as changing to smaller 9x47 prop also no change in behavior. If money permitting i would probably built a new aluminium hexa frame as the DJI flamewheel arms i suspect could be too soft…"
APM 2.5 AC 3.0.1 DJI 550 Flamewheel.F30 ESC SimonkMultistar 2216 800kv10x47 Slowfly.My hexa is flying perfect in dead calm, but it behaves like a different animal when there is a slight breeze. It just wants to tilt in certain direction and slow…
