HI everyone, I am using an APM2.5 with ArduCopter3.X. I am controlling the copter with my laptop keyboard using a 3DR radio telemetry, MAVproxy and a DroneAPI code. Every thing used to work fine, until the last test: normally I control my copter…
Hi everyone, I would like to know what is the unit (dimension) of the mag_field (Y axis) displayed in the attached image? Thank you,Safouanmag_offindoorthromag.jpg
"Thank you Roger for all these resources and for the quick answer. You've made a great work to make using the Phantom 2 radio possible.
I will explore the code and let you know when I come to the desired result.Thank you again. :)"
"Hi Roger,Your post comes with great help for me. I am actually working on the a similar project and I have some difficulties to interface the Phantom 2 receiver with the APM 2.5. I have read your comment here and looked for forum of the German…"
Hi, I am trying to control an APM 2.5 with a Phantom II radio controller (PPM). I have connected the receiver like mentioned in this article. The following image represents the receiver Phantom 2.4 G RF V3:I have checked with an oscilloscope that…
Are there any compiled files (.hex) online to upload directly to the 3DR radios. I have upgraded my firmware without really thinking about what I was doing, and found out later that I could not communicate with the receiver. As I don't have a…
"yes Jani, you are right, I have rechecked the datasheet and it's 3.3V.I have already ordered a TPS379133 from the beginning of the week, because during previous tests I have noticed that i have a "Bad gyro health" message, and I have found that…"
"Thank you Julien for your answer, it seems that we have exactly the same problem. I have found this tutorial showing how to reburn the bootloader to an ATMEGA2560 using an Arduino UNO. Do you think that should work correctly with the APM 2.5?Thank…"
Hi Ardupilot experts, It has been a month now since I have started exploring the APM2.5, uploading official firmwares, unofficial ones and making my own code with Arduino IDE. Everything was fine since my last upload ( just disabled dataflash…