About

Please tell us a bit about your UAV interest

Dovetail from RC helicopters like all flying crafts.


Hometown:

California


Activity Feed

Scott replied to Mhct's discussion Iris+ sudden fall in IRIS
"Well...? "
Jul 8, 2015
Scott replied to Justin M's discussion 3DR Iris Screwed Me Again! in IRIS
"Were you able to post the logs outside Dropbox?"
Jul 8, 2015
Scott replied to Mhct's discussion Iris+ sudden fall in IRIS
"First thing I see is that the flight did not start with a fully charged battery at 11.4 volts. A fully charged battery should show about 12.3 volts or so. At the time of the crash your battery showed 10.4 volt. That is very low. Based on that I'd…"
Jul 4, 2015
Scott replied to Justin M's discussion 3DR Iris Screwed Me Again! in IRIS
"I'd like to have a look at (.log)"
Jul 2, 2015
Scott replied to Justin M's discussion 3DR Iris Screwed Me Again! in IRIS
"Can you post the logs outside of Dropbox? I'll have a look."
Jul 2, 2015
Scott replied to Kris Kitchen's discussion Landing drone flips over and will not turn off? in IRIS
"In the RC Helicopter world this is called "Throttle Hold" and I really think this safety feature should be considered with the drones. I think the pixhawk has some sort of crash detection, but I've seen some crash videos where the motors run on for…"
Apr 11, 2015
Scott replied to Nick's discussion Iris+ Not stable on takeoff in IRIS
"Start with the basics first. Make sure the radio is trimmed neutral and the sticks have been calibrated. Then if it still pulls forward try the calibration.

Stick Calibration
https://www.youtube.com/watch?v=m73ApapSDzc"
Apr 7, 2015
Scott replied to Eric Coronel's discussion IRIS+ parameters for Tarot Gimbal in IRIS
Mar 8, 2015
Scott replied to Scott Dongah's discussion IRIS+ moves very fast between way points.
"My first mission was the same way. My logs show I was hitting close to 40mph or about 1800 cm/s. Yet my default WPNAV-speed was set at 1000 cm/s. It was going so fast when it hit some of the waypoints it started to loop back around and then move…"
Feb 9, 2015