About

Gender

Male


Location

Brooklyn, NY


Please tell us a bit about your UAV interest

UAV Systems, Tricopter, Aerial Photography, UAV Design and Development


Hometown:

New York


Activity Feed

Sergio posted a discussion
Hi There,I have a spare GPS (3DR MTK V2.0) that I would like to use as a second GPS on my APM 2.6. Can I plug it into the "old gps port" on the side of the APM?How can I setup so the APM recognizes as a backup?Thanks
Aug 20, 2015
Sergio replied to Sergio's discussion Heading Track Issues with GPS + APM2.6 in ArduCopter User Group
"Ok, Thanks for the help."
Jul 17, 2015
Sergio replied to Sergio's discussion Heading Track Issues with GPS + APM2.6 in ArduCopter User Group
"Thanks Chris,
My only concern is that n the past when I pointed the front of the craft to an area (while on the ground) the RED tracking line would follow close to the same direction, now it moves but it is always off by 45-80 degrees. Not sure if…"
Jul 17, 2015
Sergio posted a discussion in ArduCopter User Group
Hi everyone,I've been having issues calibrating my GPS to point to the right direction in Mission planner.My HDOP is low, My SAT count shows 11-17 any given time, compass calibration was successful and live calibration picked all the point.Soo, what…
Jul 17, 2015
Sergio replied to Sergio's discussion 3D Robotics Poor Customer Service
"Got the update now.
Thanks, Sergio"
Feb 4, 2015
Sergio posted a discussion
I am still waiting for someone get in contact with me since my last purchase.All I got from them was that my order was received, and of course they charged my CC.No problem with that, but since January 30th, I have not had any update on my order,…
Feb 4, 2015
Sergio replied to David Cox's discussion Tarot Gimbal and protecting GoPro lens
"David, my $0.2 below:
Make sure your setup for the Tarot motor is high enough to avoid gimbal balancing issues. I tried using a Polarizer filter (from "PolarPro") and i got a lot of vibrations. I also had to add some tape around the Gopro3 lens…"
Jan 8, 2015
Sergio posted a discussion in ArduCopter User Group
Hi All,I am working on a project related to delivery systems and I wanted to know if it is possible to setup a mission where the quad auto-land at a set destination, wait for 15 seconds, and auto takes-off from that location (out-of-sight) and RTL…
Nov 16, 2014
Sergio commented on lloydm's blog post A Review of 3D Printing Services: Shapeways, 3D Hubs and Makerbot In-Store Printing (for PX4 and Pixhawk mounts)
"Sergio said…
Great article and thanks for sharing.
I use FDM parts (uprint) on most of my experimental builds. So far no disasters and as long as you design the parts around 0.060" (min.) you should be fine. On FDM process, is key to select the…"
Mar 27, 2014
Sergio left a comment for lloydm
"Great article and thanks for sharing.
I use FDM parts (uprint) on most of my experimental builds. So far no disasters and as long as you design the parts around 0.060" (min.) you should be fine. On FDM process, is key to select the proper…"
Mar 27, 2014