About

Gender

Male


Please tell us a bit about your UAV interest

APM


Hometown:

ITALY


Activity Feed

Silvio posted a discussion
Hi, I have a Pixhawk board from 3DR, the board working correctly in flight and with telemetry but from usb connection I'm not able to communicate with the board.I'm using mission planner and I already tried to change usb cable, pc, OS and sd…
Mar 23, 2016
Silvio replied to Silvio's discussion Help to use 2W alternative telemetry 433MHz
"Good, I did not know LoRa, but where I can buy it?"
Mar 31, 2015
Silvio replied to Silvio's discussion Help to use 2W alternative telemetry 433MHz
"Sure, soon I will experiment with an hexa"
Feb 18, 2015
Silvio replied to Silvio's discussion Help to use 2W alternative telemetry 433MHz
"This is the page of the product.
At the moment I managed to make them work with a converter TTL - RS232.
I attach two images where I analyzed the telemetry 2w and the original one. Telemetry 2W got 33dBm, exactly as it should be, so I am hopeful…"
Feb 17, 2015
Silvio replied to Randy's discussion figuring out the Antenna Tracker
"Thank you very much, now the AT finally works.I have a last question, if I have a 180 degrees servo for pitch and a 360 endless servo for the yaw, how can I configure them?"
Feb 4, 2015
Silvio replied to Randy's discussion figuring out the Antenna Tracker
"today I retried to use the AT and I have found this procedure to use it:I turned on the hexacopter, I have connected the pc to hexa (with 2 3dr radio) then i turned on the AT with a 3rd radio with the same id. AT works in this way. However if I do…"
Feb 3, 2015
Silvio replied to Randy's discussion figuring out the Antenna Tracker
"Thank you for the reply but i have other problems.My tracker is so configured:APM2.5 with two servo connected to RC1 and RC2;the 3DR radio (id 25) is connected to serial 2 and the PC via USB.The vehicle is a Hexacopter with PixHawk V3.2 with a 3DR…"
Feb 2, 2015
Silvio replied to Randy's discussion figuring out the Antenna Tracker
"Hi,I'm using Antenna Tracker V0.4 on APM2.5 and i have a problem:when I try to set PROXY_MODE to "1" whit MissonPlanner, the menu is unselectable as the image below

Any suggestions?
Untitled.png"
Feb 2, 2015
Silvio replied to Silvio's discussion Help to use 2W alternative telemetry 433MHz
"If it helps, I connected the cards as in the attached diagram.Wiring SNR6202 APM.pdfDatasheet SNR6202.pdfSNR communication protocol.pdf"
Jan 29, 2015
Silvio replied to Silvio's discussion Help to use 2W alternative telemetry 433MHz
"sorry, I meant that I set the parameter "SERIAL1_BAUD" at 9, because the telemetry works at 9600."
Jan 29, 2015
Silvio posted a discussion
Hi,I have found a 2w telemetry with rs232 interface for about 55$ from aliexpress.This is the datasheet (board name: SNR 6202) .I bought a pair of these cards, but I was not able to use with the APM 2.6.I tried to communicate the two cards to each…
Jan 29, 2015