Gender
Male
About
Location
NE
About Me:
Mechanical Engineer performing structural analysis, but more flying :)
Please tell us a bit about your UAV interest
Trying to film a bit from my beautiful country. My plane is a great experimental plateform, a Hype U Can Fly.
Hometown:
Neuchâtel
Activity Feed
"Double check the compass connector. I had the issue a few times and every time the solution was because of the female connector of the compass. Check that the 3 small plugs are well inserted inside the connector."
"I have found myself the solution. My GPS+Compass Ublox LEA-6H was not configured correctly.
See that page for details.
Ublox LEA-6H configuration"
See that page for details.
Ublox LEA-6H configuration"
Hello,I have a new tricopter frame with APM 2.6 on it. When I try to perform a compass Live calibration, it starts, but get stuck with only 3 samples saved. The figure continues to spin, but it does not take any other point.I have checked and my…
"@Arthur
Done"
Done"
"@Arthur
Well it seems to work as I can mount a USB stick as a flash drive. But I use Stickmount Software to let it recognize it. But it doesn't come with a prompt window neither.
My air module is a rctimer one, but it should behave exactly the same…"
Well it seems to work as I can mount a USB stick as a flash drive. But I use Stickmount Software to let it recognize it. But it doesn't come with a prompt window neither.
My air module is a rctimer one, but it should behave exactly the same…"
"Hi all!
I have unlocked my Nexus 7, but when I plug my telemetry module, I don't get any prompt. Telemetry has solid green LED and blinking red one. Same module connected to my laptop is ok. Then in Droidplanner, when I click on connection, it…"
I have unlocked my Nexus 7, but when I plug my telemetry module, I don't get any prompt. Telemetry has solid green LED and blinking red one. Same module connected to my laptop is ok. Then in Droidplanner, when I click on connection, it…"
"Double checked, via the 3dr config tool, both air and ground module communicate. In the terminal window I can transmit messages to both. Any parameter in the MP to change except the SERIAL3_BAUD set to 57? I have also tried with different baud rate…"
"It was my mistake. On my FTDI to USB cable, Rx is white and not yellow. With that fixed I could get out of bootloader mode without any problem.
Problem solved"
Problem solved"
Hi all!I have my new 433MHz air module. I have set both ground and air module with exactly the same settings. Now when both are powered, green led is fixed on both and both have blinking red led. So they have a bounded connection and transmit…
Hello,I have some trouble with my air radio module. As I could not get it connected it with my ground module, I have decided to force it into bootloader mode. So I shorted the GND and the CTS pins on my module. It is now on bootloader mode as the…
