Gender
Male
About
Location
seoul
Please tell us a bit about your UAV interest
researcher
Hometown:
Chennai
Activity Feed
"Still in the same point..."
"Hi thank You, I got your point and working on it, I've a small issue, I can't able to see any msg on GCS regarding the Pin status change.
I using AUX pin 6, so
BTN_Enable=1;
BTN_PIN1=55;
BTN_REPORT_SEND=1; (Note: Note that the BUTTON_CHANGE message…"
I using AUX pin 6, so
BTN_Enable=1;
BTN_PIN1=55;
BTN_REPORT_SEND=1; (Note: Note that the BUTTON_CHANGE message…"
"Hi thank You, I got your point and working on it, I've a small issue, I can't able to see any msg on GCS regarding the Pin status change.
I using AUX pin 6, so
BTN_Enable=1;
BTN_PIN1=55;
BTN_REPORT_SEND=1; (Note: Note that the BUTTON_CHANGE message…"
I using AUX pin 6, so
BTN_Enable=1;
BTN_PIN1=55;
BTN_REPORT_SEND=1; (Note: Note that the BUTTON_CHANGE message…"
Any idea if Collision avoidance using Leddar Modules/M16 Multi-Element Sensor Module or PX4FLOW Smart Camera sensors will be implemented for Arducopter firmware, now that Pixhawk 2- Pixhawk 2.1 "The Cube" has come out with much higher processing…
"Good Job...."
"Hi Anton,
Good to lesson back from you. I'm trying to make x8 multi copter(8 coaxial propellers) size of my drone is very big each propellers TM-CF 34x11 inches and T-Motor U13 the total self pay lode including Bt is around 22Kg using Pixhawk i…"
Good to lesson back from you. I'm trying to make x8 multi copter(8 coaxial propellers) size of my drone is very big each propellers TM-CF 34x11 inches and T-Motor U13 the total self pay lode including Bt is around 22Kg using Pixhawk i…"
"Hi I've worked with the above .px4 firmware for quad, which was successful, I wish to work with leddar one with my x8 and tried downloading .cpp and .h file and setups px4 toll chain for building the px4 file for my x8 but i'm failing as i'm new to…"
