Gender
Male
About
Location
Tamil nadu
Please tell us a bit about your UAV interest
image processing via UAV
Hometown:
Chennai
Activity Feed
"Hello SungTae Moon... Can your ground controller be used with pixhawk?? "
"Thanks Vesselin Goranov... that a good idea, which I could try.... "
"Thanks Harry Courter.... Couple of months ago,we start with stabilize mode and change to pos hold or auto. But recent times starting with pos hold, which could take off with less jerk..... We have never flew with loiter mode. Can you explain me why…"
"Hay Philip... 3.3.3 firmware is working good. yet we had some crash with same firmware in auto flight mode and in stabilize mode, we have checked logs, don't know what could be the reason. For each firmware update there are lot of new parameters…"
"Hay Mossbackfarm... I checked all the motors and escs. All are fine... I use vibration isolation for mounting the pixhawk. I even flew the same quad about five times before the crash (sixth flight crashed)"
"Hay Michael Burmeister thanks for the reply.... I have attached the correct file... I could plot motor outputs (RCOUT)... I will also attach .log file
"I think it is possible to crash in Stabilize mode with version 3.3.3 do to over use of the GPS…"
"I think it is possible to crash in Stabilize mode with version 3.3.3 do to over use of the GPS…"
Hay guys.... I was flying a 450quad with pixhawk3.3.3with vibration dampers, M8n gps, 3DR telemetry, BEC module and futaba transmitter. I had a clean fight in stabilize mode for about 3mins and then quad suddenly yawed in counter…
"can you upload the log file..."
"see page no 17,18.....
but I too use Airbone4G only"
but I too use Airbone4G only"
"Hay Andre K
Thank for the review. We had a brainstorming for the root cause of the problem, that it might an esc issue by not calibrating ESCs after changing of a battery of different mAh (2200mAh to 9000 mAh). Is that could be a…"
Thank for the review. We had a brainstorming for the root cause of the problem, that it might an esc issue by not calibrating ESCs after changing of a battery of different mAh (2200mAh to 9000 mAh). Is that could be a…"
"hay.... I have this same issue with ac3.3.3. When I switch to altitude hold mode the quad suddenly drops with the throttle stick in the mid position. When I reviewed my log it shows, the desired altitude dropped so the quad. I think it could be a…"
Hi I am using a pixhawk3.3.3 with a quad. yesterday I was flying in altitude hold mode, suddenly quad flipped and drown into a pond. I couldnt recover pixhawk, esc and battery. out of four motors two were good and we couldnt check other two.…
I using 3dr clone bec module. I calibrated the bec module in initial setup, set measured voltage 12.3 after measuring the battery volt by a multimeter. after a flight, I found that the voltage does not change in the telemetry data and In dataflash…
"Did you find any software that finds no of crops from aerial image?"
"Hello Antonius Kasbergen
What is percentage error using imageJ software? "
What is percentage error using imageJ software? "
