Hi, I'm trying to use Bluetooth to communicate with my APM 2.6 telemetry port.
So far changed the baud rate of my BT module to 57600, paired it successfully on my PC and Android Tablet, but can't get it work on both MissionPlanner and DroidPlanner.
HiI was curious if I can use my radio's expo and/or dual rate to fly my quadcopter.I want it to fly a bit more smoothly on the sticks e.g. indoor flight or for video recording. In other words less sensitive on the sticks.I'm not sure if expo and dual
Hi,I have a question to the FrSKY X8R receiver.Is it possible to use the conventional 8 PWM channels on the X8R and use at the same time the "FrSKY SBUS to PWM Decoder" to get 4 extra PWM channels, in all 12 PWM channels ?Also would I need the "FrSKY
Problem !Twitches on my quadcopter only occur if the input of the APM's ch6 gets high input (100%). Like when a switch on the Tx is in position 1 or a nob is turned up.When I reduce the input of ch6 to about 50% or disconnect the wire to ch6 entirely
Hi,I set the super simple mode to ch7 / ch8 at the Mission Planner APM:Copter Pids.When I was flying to test it, nothing happend. It seems super simple mode doesn't work if set on ch7 opt or ch8 opt.In the instructions under "simple and super simple
I have some serious problems with my 3DR Quadcopter with APM 2.5 and 3.0.1 firmware.
When I fly, the Quadcopter is twitching about ones every couple minutes in one direction. Forward, backwards, left right and even upwards. Also sometimes the signa