Gender
Male
About
Location
Springfield, MO
Please tell us a bit about your UAV interest
Bobby, Computer Science
Hometown:
Springfield
Activity Feed
I got my Taranis Plus bind to Pixhawk with no problem But when I did a Radio Calibration, it response if my Radio is in Mode 1 but My R/C is Mode 2 (Throttle on left side) How do I set it to Mode 2 ?Also I get a message Bad Compass health as well…
"Thank you for all your help!
Have a great flying year.
Bill"
Have a great flying year.
Bill"
"I went ahead and clicked OK then click Connect
Seem to be working now .. when I move the pixhawk yaw, it show it being yawed on the MP.
Thank you
Bill"
Seem to be working now .. when I move the pixhawk yaw, it show it being yawed on the MP.
Thank you
Bill"
"BTW no need to feel sorry for me being Deaf, I was born Deaf and been Deaf for the last 50 years so I didn't lose anything since I never had it to begin with ;)
I do feel sorry for those hearing folks who lose their hearings later in their life and…"
I do feel sorry for those hearing folks who lose their hearings later in their life and…"
"it been over 20 minutes now, some leds still flashing, Click OK or leave it some more?
Bill"
Bill"
"The 3 led on one side
nearest to Pixhawk label - soild green
middle - rapid blinking amber
last - blinking blue
Other side - one solid green
last - off
Led in middle - blinking yellowish two blink pause two blink pause repeats
switch led -…"
nearest to Pixhawk label - soild green
middle - rapid blinking amber
last - blinking blue
Other side - one solid green
last - off
Led in middle - blinking yellowish two blink pause two blink pause repeats
switch led -…"
"The biggest led in the middle? One near the arrow marking?
It been about 10 minutes still flashing... Keep waiting?
Bill"
It been about 10 minutes still flashing... Keep waiting?
Bill"
"What do I watch for onboard LED to know it done updating firmware and click "OK" since I cannot hear the musical tones?
Bill"
Bill"
"Ok adding a beeper fixed it and it updating firmware.
Now it said Please waiti for musical tones to finish before clicking OK
Since I am Deaf,, how long should I leave it before clicking OK? 5 minutes? or when center LED stop flashing?
Bill"
Now it said Please waiti for musical tones to finish before clicking OK
Since I am Deaf,, how long should I leave it before clicking OK? 5 minutes? or when center LED stop flashing?
Bill"
"Beeper must be attached? I am Deaf so I have no use for beeper.
I will go attach it now and try again.
BIll"
I will go attach it now and try again.
BIll"
Howdy, I recently got a brand new Pixhawk directly from 3DR (Yes I paid more for a genius one) and when I installed Mission Planner then plugged my Pixhawk into USB. First thing I do (after reading manuals) is go to the firmware upload, I selected…
"Cool keeping an eye on your post when you do your first fly testing, please report back on your post
Thank you
Bill"
Thank you
Bill"
"i plan to built a Tarot 680 Pro with DJI E800 kits but my concern is same as your since i plan to use Pixhawk FC and how do we calibrate for DJI motors
Hope somebody can answer to our concerns
Bill"
Hope somebody can answer to our concerns
Bill"
