Location
Toronto, Ontario
About
About Me:
Prone to "pilot errors"
Please tell us a bit about your UAV interest
Quads for photography
Hometown:
Toronto
Activity Feed
"I ended up on this thread researching why my setup was drifting in Position Hold mode. I am using QGroundControl Station (QGCS) not Mission Planner and I had done all the sensor setups etc... all greeen on sensors and config... first flight and it…"
"Thx. Ivan R. Makes it all worth while when you get a reply like this!
The other thing I will add was I was struggling using Mission Planner with Pixracer having issues with compass calibration, getting it to connect via wifi etc... and I switched…"
The other thing I will add was I was struggling using Mission Planner with Pixracer having issues with compass calibration, getting it to connect via wifi etc... and I switched…"
"A solution...solved... an answer... resolved...
I know I am coming into this a year later but I just got my Pixracers mounted on a drone and I am trying to use Spektrum DSMX satellite receivers and a Spektrum DX9 transmitter and I now have it…"
I know I am coming into this a year later but I just got my Pixracers mounted on a drone and I am trying to use Spektrum DSMX satellite receivers and a Spektrum DX9 transmitter and I now have it…"
"I had a newer version like 1.31 and the Custom and Beta Firmware options were visible but upgraded to 1.34 and they went away. Others mentioned the Advanced View on the Config/Tuning but I wasn't seeing that option. Its Layout option in…"
"You are looking for 220
You circled 122 or 1200 ohms... or 1.2K...
In a pinch the 101 below that would work but add load to the 3.3v supply
Like I said, there are LOTS of 220 ohm on old APM boards... none of those retired in your box of bits?"
You circled 122 or 1200 ohms... or 1.2K...
In a pinch the 101 below that would work but add load to the 3.3v supply
Like I said, there are LOTS of 220 ohm on old APM boards... none of those retired in your box of bits?"
"As best as I can tell, this should be the location. or I should say this is ONE location... there are a few but this looks to me to be the easiest location. You don't replace that component, you solder the 220 ohm resistor on top of (i.e. in…"
"Not seeing the LSM303 chip on either of your pics so I am no use to you on this one. Don't know what to suggest. Sorry."
I have been using Droidplanner 2 on an android tablet for a while and just recently upgraded to Droidplanner 3 or now apparently known as Tower. Works great... except...Droidplanner 2 used to draw an orange track live as I flew my drone (not sure…
"I purchased a 2.4.8 clone from Goodluckbuy, my first pixhawk, and I guess the "you get what you pay for" addage applies... no board layout posted, no schematic posted.
But I undertook the hardware fix. Here are pics showing the location and the…"
But I undertook the hardware fix. Here are pics showing the location and the…"
