"Mine is also showing black screen only.
If bypassed all is good.
From the start i used two bats. One for APM and one for VTx Cam and OSD.
Do i need to connect two GNDs together for it to work???"
"In my case it raises when Alt_Hold or Loiter modes are engaged.
Tried ALT_THR_P and I and any suggestion from the wiki without success.
If POS_HOLD is selected it holds position perfectly.
Any ideas??????????????"
"Tried all firmwares from 2.4 to 2.7.1 which i think is the latest and nothing.
Actually in 2.7.1 everytime i select the NMEA in the GPS_PROTOCOL i get no flashing blue led at all anymore.
If i choose any onter protocol the led flashes.
Why my board…"
"Hi,
Ì am trying to tune my Ardupilot but it seems hard to do it successfully.
When i switch to stabilize for fine tuning the servos respond correctly but are constantly jitering.
I use:
Easyglider Pro
Ardupilot with blue Shield
RangeVideo XY and Z…"
Hi, I am looking for a budget GPS unit to use with my Ardupilot for RTH.Is this unitMediaTek MT3329 GPS 10Hzplug 'n play with ardupilot?. If not what to i need to make it be?.Regards,Teo
"Hi,
I will be searing a Locosys LS20033 GPS between Ardupilot and EZosd. I would appreciate if anyone could tell me if i need to power the GPS from the Shield in order to make use of the GPS auto shut-off feature when uploading or it is OK if i…"
"Hi,
Can anyone direct where i can find a schematic of the FMA XY sensor board. I remember seeing it somewhere but can not located now. I would appreciate any help.
Regards,
Teo"
"Hi to all,
I managed to burn the little mosfet on the FMA sensor board and i can not find any info about it so to be replaced. Any info from anyone that knows what i am looking for is appreciated.
I attach a bad mobile photo of the thing.
Thanks
T.B."
"Thank you for your help but i think i don't have all things clear.
I have an Ardupilot board, Locosys LS20033 GPS receiver and FMA Co-pilot on a composite power sailplane and want to use them as a RTL device when rc signal is lost or when i want it…"
"Hi to all,
I am configuring my ardupilot but i have a question.
Is it normal for the rudder and motor to run for three short times during start up?
Thank you
Teo"