Gender
Male
About
Location
Bern
Please tell us a bit about your UAV interest
Interested in UAV for photogrammetric applications
Hometown:
Bern
Activity Feed
"Hi Gary,
thanks for your help and sorry for the very late reply.
Now I'm again on the at project and I wanted to make sure.
So I have only to set the Pixhawk only to a usual Octocopter design?
Thanks.
Thomas"
thanks for your help and sorry for the very late reply.
Now I'm again on the at project and I wanted to make sure.
So I have only to set the Pixhawk only to a usual Octocopter design?
Thanks.
Thomas"
Dear all,I'm planning an easy and light octocopter.I would like a kind of H-design.My question is now: How to configure the pixhawk? Which frame type should i use?I would like to connect all 8 motors independent to the pixhawk. I dont like to…
"Sorry to open such an old conversation.
But I had the same problem and think I have the solution.
The log_bitmask should be set to "nearly all" to log the CAMERA infos in addition.
Hope this helps some people in the future.
Best regards
Thomas"
But I had the same problem and think I have the solution.
The log_bitmask should be set to "nearly all" to log the CAMERA infos in addition.
Hope this helps some people in the future.
Best regards
Thomas"
"Thanks for the reply.
I have the original one from 3DR, so no clone or something.
I bought a RTF system, this works perfect. And a spare one. From the spare one I build up a 500g quad, there I have this problem.
Best regards
Thomas"
I have the original one from 3DR, so no clone or something.
I bought a RTF system, this works perfect. And a spare one. From the spare one I build up a 500g quad, there I have this problem.
Best regards
Thomas"
"I had the same problem.
Flying a auto mission and suddenly the quad changed to loiter.
Any news about this problem?"
Flying a auto mission and suddenly the quad changed to loiter.
Any news about this problem?"
"Sorry I am at the moment not in the office but as far as i remember i solved the problem by inverting the channel. Like this it reaches the 1800 easily but on the other side it doesn't go very low on the other side.
I will post more details when I…"
I will post more details when I…"
Dear all,I try to setup my Spektrum DX7s for the CH7Opt.I would like that the copter returns to launch when I switch the AIL/DR switch on my DX7s.Unfortunately when is witch it, the max will not reach the 1800 (minimum) as it is necessary according…
"Hi Labiba,
do you have any reply to this question?
I'm on the way to buy a Pixhawk and I would like to know this too.
Best regards
Thomas"
do you have any reply to this question?
I'm on the way to buy a Pixhawk and I would like to know this too.
Best regards
Thomas"
Dear all,now I'm looking into the use of an ArduCopter for photogrammetric image acquisitions.Therefore I have some short question:The ArduPilot can release images on certain points: - Is there a limitation in number of points? - Is it correct…
