About Me:
Working on UAV project
About
Please tell us a bit about your UAV interest
Working on UAV project
Hometown:
Los Angeles
Activity Feed
"Just seeing if anyone had any thoughts?"
"If anyone has experience with this and can tell me what to expect I would much appreciate it. Thanks."
I have a fixed wing tricycle gear airplane I am trying to implement auto-takeoff with. Also, I am not using an airspeed sensor so I would need to hold a constant climb pitch. Testing the feature with the engine off I see that the throttle goes to…
"We had one crash, which I believe was due to a receiver failure in manual mode and fail safes where not setup correctly, however, I saw a similar experience with another DIY Drones member and they believe it was something to do with the Pixhawk. …"
I have used both the APM 2.6 and Pixhawk (fixed-wing aircraft), however, I seem to have had greater success with the APM. I would like to hear from those that have also had experience with both (used on fixed-wing aircraft) and see which one you…
I have found the setting within the parameters that enables the use of a second GPS. I am assuming that the firmware automatically selects whichever GPS has the lower HDOP.I am under the impression that the Pixhawk has dual baros and…
When using the power module with the APM, what is the minimum recommended C rating of a Lipo battery?
"Tried that, but same situation."
"If each servo is independently connected to the APM then they work fine. It is only when using the Y-harness and it is just one rudder. I have tried another y-harness with no luck, as well I have tried another receiver."
"yes, they need to be mixed for optimum performance."
I have a 2 servo elevator setup which is mixed with my controller (One servo plugged into elevator channel, one plugged into aux). How can I get this to work with Ardupilot? Thanks.
Could this be used for 3g telemetry (http://www.netcommwireless.com/product/m2m/ntc-4000)?
"Anyone have any thoughts on using this (http://www.netcommwireless.com/product/m2m/ntc-4000) for 3g telemetry?"
Could this be used for 3g telemetry (http://www.netcommwireless.com/product/m2m/ntc-4000)?
