"anyone know if this bug has been resolved? I am using the same setup (7008 rx using 14 channel mode) and get a variety of issues during calibration and setup. as an example, channel 3 (throttle) seems to get mixed into channel 6, no response to…"
If I want to use a 3s 2200mah lipo to power everything --apm, rx, and servos (nitro motor so no bec/esc), are there any issues with using the power module and leaving the jp1 jumper connected? there are 4 standard-size servos that need to share the…
"Thanks, Chris. One more question. What is the other deans connector used for? I assumed it went to the esc and that the apm power module sits between the lipo and the esc."
"Just so I understand. Can the apm power module be used just for apm power with a separate lipo & esc/bec to power the motor and servos? And the power for the rx comes from the apm power module via the apm board?"
I crashed my apm2-equipped airplane a week ago and need to get the apm repaired. I sent email to the store's technical support and received an automated 'thanks for your email' response. It's been nearly a week and I have not received any more email…
"problem solved. throttle was reversed. I must have done 20 flights in auto mode with it reversed, trying to understand why the throttle was going as low as it could. Of course it did, it thought that it was increasing the power! In fairness, how…"
"Same problem. I posted regarding this with my nitro-powered Great Planes Stick 60. As a side-note, I would like to understand what you should populated in the mission planner screen, lower right-hand corner where it wants the absolute altitude for…"
Hello, new member. I have searched the site a lot about this without any luck. I'm using apm2 in a Great Planes Stick 60 airplane. The software version is very recent, no more than a week or so old ( you can assume early July 2012 version on…