Gender
Male
About
Location
Warsaw
About Me:
Editor
Please tell us a bit about your UAV interest
RC Pilot for many years, interested in doing areal photography
Hometown:
Ruda
Activity Feed
Dears, the work on my self-designed 3D printed hexacopter has been finished:) Some pics attached.It can fly pretty well in all modes but I wanted to tune it with the Autotune functionality.After the drone took off I switched to Althold and turned on…
"Hi,
I know the meaning of these messages, thank you.
As I already wrote in my first post - I am getting two messages one after the other: No GPS...No Fix...No GPS...No Fix and so on. It is strange, I know, and it is confusing for me and that's I am…"
I know the meaning of these messages, thank you.
As I already wrote in my first post - I am getting two messages one after the other: No GPS...No Fix...No GPS...No Fix and so on. It is strange, I know, and it is confusing for me and that's I am…"
"Hello,
the message in MP after swapping: No GPS."
the message in MP after swapping: No GPS."
Hi,tried to connect the uBlox neo 6m-0-001 with compass to APM 3.1 mini to the GPS slot (compass to SCL/SDA, GPS to GND/5V/RX/TX).The power LED on the GPS board in on, compass configured and works fine. I cannot get the GPS working,…
"I don't know the solution but I have the same problem. You wrote it happens sometimes, on my APM it is the rule:( I posted this problem to this forum yesterday.
I would be grateful to get some information from you about solving the problem when you…"
I would be grateful to get some information from you about solving the problem when you…"
"Hi Chris,
I know you are a true encyclopedia when it comes to APM and arducopter. I posted a question to the forum but did not get any answer. Below is my question.
After the ESC calibration all 4 motors on my Quadcopter behave very strange. When I…"
I know you are a true encyclopedia when it comes to APM and arducopter. I posted a question to the forum but did not get any answer. Below is my question.
After the ESC calibration all 4 motors on my Quadcopter behave very strange. When I…"
Hi all,I am really very impressed how many information about software and hardware configuration for my Arducopter I can find in the manual on the site diydrones.com. It is really a great job, thanks for all the people involved!But as a beginner in…
"Thanks a lot for your help:)"
"There are two: 5V and 3.3V. you can take a look at the link in my previous post - it shows the reverse side of the breadboard with symbols too"
"I am not an expert in electronics but very interested in building drones. Please help me solving problem with setting up the XBee communication. I have two XBee Pro Series 2 modules, USB board and XBee Explorer Regulatated from Sparkfun,…"
