Hello everyone,I have been working on a heavylift quadcopter for some time now. I have used U8 Tmotors on 6s and had good success with flight time but suffered in stability. I have been looking to change to the U10 Tmotor or the KDE 7208 or 7215 moto
Read more…Hello everyone,I know that large, heavy lift quadcopter might be a nitch in this community but I see that there are several here building these.From all that I have read and experienced when building them with low kv, large motors there are some prob
Read more…Hello all. I had a unusual event today. I have two 6s batteries connected in parallel on my quad. They are both 16000 mah batteries rated at 15c. After the flight I let them rest and then put them on my charger. When the charge was complete i was ast
Read more…Here is the basic setup for my Quad.
1200 mm motor to motor frame.
Pixhawk Flight controller.
Castle Creations 50A ESC's
6s 15C Lipo Battery
AttoPilot battery monitor
U8 Tiger Motors
28" Tiger Props
Taranis 9XD Radio
Minim OSD with a 5.8 ghz video transmitte
Read more…I could use some help resolving stability issues while in loiter. I set up my heavy quad using Auto Tune. While trying to test Loiter stability my quad started to loose control. I tried to keep it in Loiter as much as possible. When it began to loose
Read more…I am experiencing trouble with the current sensor. I am using the attopilot 180a. In mission planner it does not detect any current flow. I thought it was a problem with the Pixhawk but after speaking with 3D Robotics we chased down all of the known
Read more…Let me start off by saying I have been searching the discussion boards for some time now and have now found many if any that are building large Quads using the Pixhawk and the U8 Tiger motors. I am a bit of an overachiever and and wanted build and ef
Read more…